Electronics Forum | Wed Aug 24 11:32:08 EDT 2016 | mnorthey
Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0
Electronics Forum | Thu Sep 15 16:40:55 EDT 2016 | zippi
Hello, i have a problem with the Calibaration of my Assembleon Eclipse II. There is a problem with the down Z Position of Head 2. They are 2mm deeper as Head1 by picking up any Componend. Laser High are OK. How Can i setup the Head down High.
Electronics Forum | Mon Apr 24 03:39:42 EDT 2017 | bukas
hello everyone, i'm experiencing some problems with Samsung CP45FV NEO fiducial camera. image is running trough display(something like when you look display trough phone camera, but runs horizontally) and it has offset. the problem is that offset ch
Electronics Forum | Thu Mar 08 15:04:20 EST 2018 | emeto
Both of these are very old platforms. I used them both in the past and they are both good machines. The question is how are you planning to keep them going? Spare parts availability? Knowledge to fix them? Calibrate them?Does manufacturer support the
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Fri Aug 17 07:50:03 EDT 2018 | muzzy
Hello Stephen, thank you for your reply. This machine uses binary files to store the settings (or at least stores backups as binary files). Also, this "MS Parameters" window contains not only parameters alone but also calibration procedures, so it wo
Electronics Forum | Fri Oct 26 09:43:19 EDT 2018 | dnachristen
Hello! A member here graciously sent me the pinout I needed. I now have 24v to the feeder in the test rig, but need to know what type of signal the feeder requires on pin 9 to electronically index. Anyone have a clue? I tried ground signal and 24v, n
Electronics Forum | Tue Oct 30 12:47:17 EDT 2018 | padawanlinuxero
hello try to calibrate the Z axis, check the cable must be damage, check if the transducer is loose, just some options from the top of my head, have you try getting into service and make it work there? if not try that too.
Electronics Forum | Sat Dec 01 13:44:07 EST 2018 | horchak
Is this across different assemblies or components? HAS the machine been calibrated lately? Are you using an adjustable fixture or dedicated tooling plate? Is it a rotating table and are you using it? Was program generated with CAD data or self taught
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a