Electronics Forum | Thu May 02 12:32:29 EDT 2002 | jmathis
Hello, BUY Juki! Trust me on this one, I have experinced both and I may change careers if I find out I'm going to support another Quad line. There is a reason why that company struggles every year. Quad is not in the same market with the Fuji and
Electronics Forum | Tue May 21 14:12:19 EDT 2002 | dougt
I'm starting to see faducials used more and more on pick and place equipment and this sounds like a good place to use them. Does anyone out there have feeders with faducials on them yet? I'm told that a couple machines are running these to place 04
Electronics Forum | Sun Jul 28 23:11:52 EDT 2002 | caldon
Sam - If I owned Cal Driscoll Electronics and were looking for a rework system a few things I would consider: 1) Convection is key (IR as an under heater or pre heat is ok but not as the main heat source). 2)programming simple? User Friendly and easy
Electronics Forum | Sat Aug 17 03:39:13 EDT 2002 | shrikant_borkar
Monitor daily Machine MIS data for parts rejection ofcourse your weekly/monthly preventive maintenance must be regular. following steps- will be helful 1. qulaity output from machine by taking immidiate action over online detected faults. concentrat
Electronics Forum | Fri Feb 07 15:16:46 EST 2003 | Claude_Couture
Bulk parts cassettes... another idea that must have looked good at the time. Too bad the manufacturing trend went from low mix / high volume to high mix / low volume. I guess the feeders have to be too complex to feed the part properly to the machine
Electronics Forum | Wed May 28 14:35:47 EDT 2003 | davef
Wow, you're very correct. I guess we use silicone to calibrate our machine, as follows: XPS spectral measurements of dimethyl silicone should include O(2s) at 25 eV, Si(2p) at 102 eV, Si(2s) at 153 eV, C(1s) at 285 eV, and O(1s) at 533 eV. The C(1s
Electronics Forum | Fri Sep 05 08:28:18 EDT 2003 | pioneertechnology
Hello We have several BD12's but I do not understand what you mean by calibration data. The machines we have, all come with the following disks HRX-11, SYSTEM, IPDATA. If you are missing any disks you can contact KME with the serial of the machine
Electronics Forum | Mon Sep 22 12:46:17 EDT 2003 | cyber_wolf
We had two of these machines. I have worked on many different types of equipment, and these machines were by far the most frustrating to work with. The calibration is a pain in the butt and it does not seem to do what it is supposed to. Also, the sof
Electronics Forum | Tue Jan 13 01:20:31 EST 2004 | mantis
Hi All, I have seen this issue on a QFP160.Firts of all as previously suggested if the board is wave solderded make sure that you are not seeing topside reflow as the board goes over the wave.Secondly you should verify your reflow profile.I seen this
Electronics Forum | Wed Apr 07 11:36:41 EDT 2004 | stefwitt
Your machine will have to have a reference position. From this reference position, you determine all other machine positions. If the camera is attached to the head, you could place a glass slug and measure camera-nozzle offset, by placing the slug w