Electronics Forum | Wed Jan 21 04:07:09 EST 2015 | xboxhaxorz
Most serious rework stations are from ersa, pdr etc; We actually wanted a fully automated system with split vision and in USA that would probably cost around $50k. We decided on a ZX360 which is about 300 lbs and it worked quite well without issue fo
Electronics Forum | Mon Oct 13 18:10:30 EDT 2014 | ilavu
Hello, I am looking for the backup (mapping and calibration) of Universal GSM2 with both beam with Flexjet head. I am having problem with placement from beam2 is randomly off. Either X, Y or theta. Beam1 is placing all the parts with no problem an
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue Nov 18 10:24:45 EST 2014 | jpal
Feeders for your SMT machine. They can be a considerable expense, and you will hardly ever have enough if you have a high mix of products. You will wear out nozzles on the pick and place also. I don't see AOI in your machine list, so at least you wil
Electronics Forum | Fri Jan 16 16:57:14 EST 2015 | dilogic
I doubt you will be able to get satisfactory results with 0201. 0402 is another story. When doing 0402 projects, we use only electric (MP) feeders and always at the same feeder slots (feeder teach done for each of them). MPF08 nozzle works fine. Also
Electronics Forum | Fri Feb 13 08:41:45 EST 2015 | emeto
Hi, I have MV-7xi from Mirtec. Mine is equipped with the best camera they have as well as telecentric lens which give you very good resolution and view. Machine handles very good most of the defects in SMT. However, when we go to the solder joints i
Electronics Forum | Wed Apr 08 14:41:35 EDT 2015 | kevinb
I have a Quad QSV-1. When I was teaching the fiducials, an error came up on the screen. ABNORMAL PROGRAM TERMINATION came up. It might have read something different but this was close. It then closed out of the quad program and went to the window
Electronics Forum | Thu Aug 27 09:18:57 EDT 2015 | fcmtechnician
Hi Don't know your reflow brand, but try to decrease the blower speed...is possible that air blow out the componets! For vibration, chain related issue, etc open your hood and start the oven in colder recipe with pcb inside! ( put the service key o
Electronics Forum | Mon Jan 18 02:49:03 EST 2016 | nirmex
1-Machine speed. 2-New Head H24 and DYNA Head. 3-New Feeder type W08f 4-New Part Camera. 5-New Y-Axis Flat cable design. 6-New GUI with Touch Screen. 7-Panel Height detection. 8-Feeder raising detection. 9-NPI tools support. 10-Overall machi
Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old