Electronics Forum | Wed Feb 21 14:10:36 EST 2007 | bobpan
The quad 1000 is best used for 0805 parts and larger. It is termed a chip shooter meaning 'for the most part' passives only. There is no optical alignment and it has mechanical centering using precisor pads. Fiducial finding is done with a beam and n
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Electronics Forum | Wed Mar 14 01:51:55 EDT 2007 | CHITRA K
We would like to buy a good microscope for visual inspection of SMT PCBs especialy for highly populated PCBs assembled with fine pitch components including BGAs . Please advise a suitable type of equipment visula inspection for volume production. A
Electronics Forum | Wed Apr 11 14:57:31 EDT 2007 | itwasbill
Hi all! We are placing BGA's using a QSV-1 pck and place machine. I believe our profile has the correct information but we continue to get vision results not available when we inspect the part. Our screen appears as follows: NO RESULTS AVAILABLE PAR
Electronics Forum | Tue May 01 16:36:12 EDT 2007 | ratsalad
I have been working with GSMs since 1999. Mostly, I've been programming them but for the past 2 1/2 years or so I've also gotten to know them mechanically. I think they are great machines. If you are looking at Flex head GSMs (4-spindle) they won'
Electronics Forum | Wed May 02 12:22:30 EDT 2007 | SWAG
Make sure you get a good upward looking camera combo. 4.0 on rear and 2.6 for PTF (platform tray feeder) parts is my favorite. Easy to wrench on, calibrate (if you have a cal. kit), and easy to program. Single beam will run at 2000+ cph and dual b
Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Thu Aug 16 10:59:08 EDT 2007 | mika
Did You recieve any s/w with it? If something has happend to the hard drive or something could happens in the future then you need to reinstall... S/W ver. is written on the the s/w package. It should contain s/w for: The OS (Operating system), Visi