Electronics Forum: camera (Page 126 of 128)

Low volume prototyping

Electronics Forum | Fri Jul 13 17:16:49 EDT 2007 | jmelson

I just got a used Philips CSM84 pick and place machine for $1500. I had to widen a doorway and rent a forklift to get it inside, as well as have it shipped. So, the total cost was much higher, but still under $10 K. I may have gotten lucky on this

Mydata A12 tool tip damage

Electronics Forum | Fri Jul 20 08:11:38 EDT 2007 | allgood

Well yesterday was uncharacteristically warm for a British summer! I always have the panel off the end of the machine at all times and certainly used to have a large desk fan blowing into it - for some reason I stopped. I had a run of strikes yeste

Soldering issues lately!!

Electronics Forum | Thu Sep 11 11:34:52 EDT 2008 | patrickbruneel

Interesting observation Manuel. I will be blamed again for crying wolf but look below a lot more defects will soon see the daylight all related to lead-free. This information was posted at the tin whisker forum by Bob Landman of H&L Instruments.

a hot tip for bad boards

Electronics Forum | Thu Apr 11 10:17:17 EDT 2013 | ericrr

Some times the PCB manufacture sends PCB panels with bad circuits, there are three ways to make these PCB without placing parts on the bad circuit, Well two in fact plus my method. (1) Placing a light mark on a dark background (or reverse) then the

Older AOI Inspection Systems

Electronics Forum | Thu Oct 18 08:27:46 EDT 2018 | spoiltforchoice

They visited our factory once bringing the desktop variant with them quite a while ago (~8 years perhaps when they were still called something else). At the time it was an FAI machine first and foremost with some "AOI like" features that perhaps o

Homing Contact systems / versatec 3S. slow movement.

Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward

I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be

Flason SMT Products

Electronics Forum | Thu Oct 04 00:07:29 EDT 2018 | gaintstar

flason smt SMT spare parts: http://www.flason-smt.com/product/SMT-spare-parts-Assembleon-Controller-Bvm-5322-216-04698.html http://www.flason-smt.com/product/SMT-spare-parts-Assembleon-Control-V2-1-Rev-B-8mm-4022-594-10010.html http://www.flason-smt

Re: Vision Inspection Systems

Electronics Forum | Thu Apr 30 16:13:38 EDT 1998 | Chrys

Hello - I am interested in obtaining information on the possibility of integrating a Vision Inspection System with an SMT line. I am aware of systems which may be used to gather placement data and such, but are there any systems whic

Re: Fond Farwell II

Electronics Forum | Sun Apr 18 00:47:11 EDT 1999 | Steve Gregory

Yeah Earl, I hear ya... I registered, but did so rather grudgingly. Ya'll must've noticed that I haven't been here much lately. I really haven't thought much about why, but maybe it's been a subconscious thing...like it's too much work to go here an

Informations about Traceability

Electronics Forum | Fri May 16 10:06:44 EDT 2003 | pjc

Traceability of raw material, personnel and equipment performance during product manufacture: Tracing raw material is done by recording the material mfg.�s batch-code that they assign during the material�s manufacture. This is everything from the fl


camera searches for Companies, Equipment, Machines, Suppliers & Information