Electronics Forum: camera (Page 51 of 128)

sot363 placement issues

Electronics Forum | Thu Apr 20 03:40:21 EDT 2006 | aj

All, Thanks for the advice. Turns out that the part was using the Wide View camera, switched to Narrow ,problem gone. aj...

sot363 placement issues

Electronics Forum | Wed Apr 12 09:33:10 EDT 2006 | jdengler

We had a similar problem and needed to slow the cam speed. The surface of our component was rough so I suspect we did not get a good seal for the vacuum and the component was drifting on the nozzle after the camera. Jerry

MPM Hi e

Electronics Forum | Thu Jul 27 22:27:45 EDT 2006 | seth

Vision X-Y maintenance procedure, please advise. I have problem with camera not park so often time, and I don't have any solution accept buying a new vision Y right stepper motor, but that's just too much money roughly 2500 dollars.

MPM Hi e

Electronics Forum | Tue Aug 01 18:12:18 EDT 2006 | SWAG

Check to make sure the platen and the camera are meeting the sensors that tell the machine they are "parked". Find these sensors and flag them. Look for indication they are working in the input screen. Also, make sure the sensor flags can go into

MPM Hi e

Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG

Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo

QP341 Mark Reader (HELP NEEDED)

Electronics Forum | Wed Jun 14 16:27:13 EDT 2006 | vikkaraja

Talk to Fuji regarding this issue, there is retrofit kit for the mark read camera amp.( it's black color box on top of the machine from side one on your right hand side). And also check you software there might be upgrade available from fuji. I hope

would like any input on MPM problems

Electronics Forum | Fri Jul 15 13:56:18 EDT 2005 | chunks

Here's an easy one. Make a camera that looks up at the board a non-mirror image. You could keep the mirror image toward the stencil since stencils rarely have any legend on em.

MPM AP25 Print Repeatability Problem

Electronics Forum | Fri Sep 22 11:51:32 EDT 2006 | chris g

Have you tried doing a short diagnostic test? That will check the repeatability and backlash of the axis. Did you use the C-tool when calibrating the camera?

Advice Needed between a DEK 265GSX and a MPM UP3030!

Electronics Forum | Fri Oct 06 11:41:11 EDT 2006 | Bill

UP1500 was not a real MPM machine, so not relevant. UP1500 was an SMTech (UK) machine, different sofware, camera, etc.... than an MPM machine. AccuFlex is now real MPM.

Autoprogram

Electronics Forum | Mon Nov 13 12:14:17 EST 2006 | pforister

Jax, I called BP Micro. They don't have offline programming capabilities for the quad machines. They use the handheld and camera system to program the pickups and placements. That was a good try, I forgot BP Micro was using the IIC - IVC machines


camera searches for Companies, Equipment, Machines, Suppliers & Information