Electronics Forum | Tue Feb 28 17:45:56 EST 2012 | acsscott
So, got the Topaz X up and running. It has (4)FNC nozzles on 2, 4, 6, 8, and (4)74A Nozzles on 1, 3, 5, 7. We are trying to optimize it to pick up 8 components, then move over the camera, then to the PCB and place them. In the Mount data, we load
Electronics Forum | Fri Jul 18 16:57:54 EDT 2014 | guts1872
In the middle of my run yesterday the camera LED's in front and back wont turn on during inspection step. I can manually turn them on in the program edit screen, but as soon as I try to inspect a part they turn off. Was hoping a restart this morning
Electronics Forum | Mon Sep 15 23:59:09 EDT 2014 | marcelorotofrance
Hi evreybody I wish to know if somebody can describe how is made a "Calibration Slug" for centering the upward camera of a QUAD IVC machine. The instruction manual mentions a slug that is attached with vacuum to the "Vision Nozzle" and there is some
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Thu Jul 07 11:52:25 EDT 2016 | proceng1
We just pulled a Speedline Accuflex printer out of storage. After programming a board and stencil, and calibrating the fiducials and everything, we do a test alignment and bring the board to print height. It is off. I've done it now with two diffe
Electronics Forum | Wed Aug 07 14:51:31 EDT 2019 | alexeyzb
Hello! I used three SpeedPrint 210avi in our factory. They worked ok, but i had some problems: 1) Printer foil clamps. Steel thin blade which press PCB on table is connected to metal base by glue. As a result you need to change it every month, but af
Electronics Forum | Tue Sep 24 15:32:22 EDT 2019 | kurtiss
During production our MPM Accuflex stopped working. When going into "Play" mode to run production it almost instantly Pauses. When going into vision setup it fails to load the PCB saying "The PCB Did Not Load". Ignoring this error and trying to read
Electronics Forum | Tue Jan 05 13:26:13 EST 2021 | ppcbs
We are working to upgrade our BGA Rework Systems to place BGA's up to 150mm in size. We are encountering an issue that I wanted to pose to this group. When we get above 50mm in chip size, which is the field of view for the vision systems Prism, the
Electronics Forum | Fri May 14 07:00:32 EDT 2021 | tommy_magyar
Hi Daisy, I have worked with Viscom AOI before, I am in training with Omron now, but there were many times when this happened to me in the past. Recommended things to do: - Check for duplicated analysis - the AOI might spend time with taking pictur
Electronics Forum | Mon Nov 08 14:45:19 EST 2021 | nparo
Greetings, I have an AOI machine that I am programming however I have ran into an issue with the board grab function. I an creating a new program and the screen should show the camera image and allow me to grab the board corners and create the image