Electronics Forum | Sun Sep 23 01:32:58 EDT 2018 | sarason
Try my program PCBSynergy to load up your machine, if you have any problems you can email me at the address on the webpage. https://pcbsynergy.com From your description you may have a camera offset issue. sarason
Electronics Forum | Fri Dec 08 18:02:21 EST 2023 | jdengler
Not sure on CP6's but CP2 through CP4 series used jigs. We now have an AIMEXIII and it uses jigs. I would bet that there are jigs for the CP6 series machines.
Electronics Forum | Fri Dec 15 07:14:10 EST 2023 | pete_b
Hello, we have some Problems with the camera of our EKRA E5. Does anyone have the Service Manual for us please? Would be great if anyone could send it to me. Thanks in advance Peter
Electronics Forum | Sat Dec 16 09:43:39 EST 2023 | madisreivik
I know, but actually we have very "deep knowledge" of that machine, probably much deeper than we wanted :) So, if any information about nozzles please share !
Electronics Forum | Mon Dec 18 14:06:10 EST 2023 | cyber_wolf
I would check with these guys. One or both most likely have these jigs. http://www.ibesmt.com/ https://www.smtresearch.com/
Electronics Forum | Mon Dec 25 17:28:43 EST 2023 | bobpan
I dont know if vision on spin fail was ever for small parts....its more for bigger fine pitch that fail in the quadalign and then given another chance to pass over the upward camera.
Electronics Forum | Thu Dec 28 08:10:13 EST 2023 | vickey
Always follow the manufacturer's guidelines and recommendations when troubleshooting or performing maintenance on the equipment. If you're unsure about any step, it's advisable to seek assistance from Fuji's technical support or a qualified service t
Electronics Forum | Wed Jan 10 21:03:02 EST 2024 | madisreivik
Vision error found: YOU MUST CHANGE LAMPS SOMETIMES ! Also, the camera front-glass (with the cutout) must be correctly positioned :) Still looking the Q error on left head. Probably mechanical problem...
Electronics Forum | Fri Jan 12 15:32:53 EST 2024 | madisreivik
Indeed I found some vacuum problems, one replaced small hose was not fitted correctly. Lets see if that helps :) Great thanks ! Also, Travis, do you have any information how to adjust the milk-plexiglass slitted covers on line scan cameras ?
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
