Electronics Forum | Fri Aug 25 11:00:37 EDT 2006 | SWAG
Thanks for the advice. This is not a Universal camera. I removed the lense from a "blown" camera and installed a new CCD that I bought from a camera shop. I only see one ring that can be adjusted on the camera itself. Not sure if it's aperture or
Electronics Forum | Fri Aug 25 23:54:26 EDT 2006 | mika
If You adjust the focus to perfection, You still need the UIC GSM calibration kit, so that the machine will know where the spindles are according to the cameras (OTHC, P2P:s, fiducial camera), X-Y-Theta-spindles, nozzle changer, feederbanks and mach
Electronics Forum | Fri Aug 25 10:29:13 EDT 2006 | Chunks
With tacky flux, the BGA is not as reliable as one that was never repaired. I believe Dave stated that the higher offset may have something to do with it. Also with tacky flux, the ball collapse form side to side varies a bit. Sometimes a ball(s)
Electronics Forum | Mon Aug 28 10:59:34 EDT 2006 | SWAG
Yea, the kapton works good. We've had great success with some pretty fine pitch BGA's. Clean the site well, place the kapton stencil and make sure it's 100% adhered. Apply kapton tape around the perimeter of the stencil for ease of extra paste cle
Electronics Forum | Mon Aug 28 12:06:48 EDT 2006 | yuceltemel
Dear SMTnet users, We will make incestment for a SMT Line in near future and the closest machine seems as Advantis AC30-AC72. For more information we are producing DVB's with 30.000 cmp including QFP208, uBGA and needed capacity is nearly 30.000
Electronics Forum | Thu Aug 31 10:15:33 EDT 2006 | Cmiller
We bought that combination about a year ago and it has been great!! Never been so happy with an SMT line. With both machines you may be able to hit 30,000 CPH but that really depends on your component mix, I would say it would be hard to get there. T
Electronics Forum | Wed Aug 30 08:06:45 EDT 2006 | scombs
The reason I asked earlier about Gridlok is that we are using the on 2 Dek Horizon printers (since Jan 06) with edge clamps and they work well. We run them in Auto mode so they conform to the board at each print so I do not have to worry about the op
Electronics Forum | Fri Sep 01 18:59:40 EDT 2006 | chrisgriffin
Fastek- From the sound of the attitude, you must be competition. And trust me, we do much more than clean them up and paint. How about you? But thanks for the sarcasm. And when you've refurbished a hundred MPM's, you tend to become an expert.
Electronics Forum | Thu Sep 07 22:09:09 EDT 2006 | Doug Eidle
Hi Sr. Tech, Please excuse C.K. He obviuouly has something virulent for breakfast. I am talking about knowing exactly what you are buying and all the associated costs and potential costs. You are making a value judgement, is the machine worth the
Electronics Forum | Tue Aug 29 11:22:12 EDT 2006 | yuceltemel
Dear Bruce, We had the same problem in the same condition. Every compnent and the PCB (OSP) has changed as lead-free and we need to solder them with SnPb. For solution we have increased the flux amount applied on PCB and the pre heat zone temper
