Electronics Forum | Wed May 17 02:32:39 EDT 2017 | bukas
Rob explained very well what it takes to start SMT line. The question is what infrastructure do you have at your factory? any category Rob mentioned can have time consuming complications and this is why you should find professional to start the SMT
Electronics Forum | Wed May 31 20:43:55 EDT 2017 | juliefarrell
Hi James, ICAPE is one of the top PCB providers in Asia. We have 35 manufacturing partners to choose from! You can imagine how competitive this makes us on price. We can provide you transparent PCBs with good quality and a great price. Reach out
Electronics Forum | Tue Aug 01 18:28:47 EDT 2017 | zsoden
Thanks for the suggestions. 1. By this are you referring to the flux specifications or the actual profile of the machine? 2. Yes, the entire machine, the solder pot and the wave nozzles have all been levelled. The better joints on one side are perp
Electronics Forum | Thu Jun 08 16:40:08 EDT 2017 | sumote
I have used one (actually 2) of these machines. The upside is you can point to the print-out and tell your customers that you do test for cleanliness, and you pass. The reality of this test is that it tests for exactly 1 type of contamination. The
Electronics Forum | Mon Jul 24 20:50:25 EDT 2017 | dawson
I'm curious why you ask this question even though I really don't know whether there is such smt assembly facility in HK. Maybe you think there is 17% VAT in the components to China outside from China mainland, but there is no tax in HK. I have to say
Electronics Forum | Wed Jul 12 06:29:11 EDT 2017 | jamesbarnhart
Soldering electronic components like electrolytic capacitors can be some of the most difficult terms in PCB repair. Electrolytic capacitors, like other components, come in two main formats. 1. Through-hole capacitors have long leads designed to pass
Electronics Forum | Thu Jul 06 11:47:10 EDT 2017 | bobpan
Are you sure the board is clamping tightly. If it moves during a run this can happen. Before reseting the machine. Go and check your feeders. If they are off the same amount....then the machine truly has a drift in that axis...if the feeders are stil
Electronics Forum | Fri Jul 07 12:44:49 EDT 2017 | tsauve
The problem is registration between the stencil & the smallest pads on the 5 substrates. Using SPI s/w I can overlay the paste layer over the PCB image to determine stretch/shrink. Our worst case was shrinkage of 10.2mil on a 5-up 300mm panel - small
Electronics Forum | Wed Jul 26 11:44:55 EDT 2017 | rgduval
Check with your board house and see if they can do jump-scoring. I haven't dealt with a fab house yet that could, though, so, while it should be do-able, it doesn't appear to be super common, IMO. Alternatively, you could sand the edges after break
Electronics Forum | Thu Aug 10 04:31:02 EDT 2017 | leadthree
The only people that can answer what you need is UL. I worked with VDE and I do not know any company that works like that. With VDE we prepare a module according to VDE standard and do an internal pre-approval - and present it. To put something ra
