Electronics Forum | Wed Apr 13 05:01:07 EDT 2005 | chandran
where can i find full standard part dimension for chip,ic,bga and others for machine mv2f,msr and msf.If there anybody know about this pls help.
Electronics Forum | Fri Apr 15 05:52:20 EDT 2005 | charly
hi Jon, does it mean the protective layer is coated after the immersion silver process? if we need to bake the PCb due to moisture issue, then we can not hold the pCB long due to the missing protective layer even with vacuum seal environment
Electronics Forum | Wed Apr 13 08:56:39 EDT 2005 | Dhanish
Hi, I need help as we are seeing high defect on label peeling off which is attached on the PCB.After remove the liner on the Lexan label,we realize there is crack in the adhesive and base materialPlease advise what test can be done to ensure there is
Electronics Forum | Thu Apr 14 11:38:29 EDT 2005 | mmjm_1099
Play around and setup the coplanarity in Fuji Flexa and see if this can help you at all. Other than that I wouldn't have a clue as to what it might be.
Electronics Forum | Thu Apr 14 12:33:30 EDT 2005 | russ
Have you checked the component height in the package data to ensure that it is the same? how about the PCB itself, could there be some warp or twist thay may cause the component to be dropped onto the board? any support problems? this is all I can
Electronics Forum | Wed Apr 13 21:47:32 EDT 2005 | Dhanish
In production,we are seeing high defect for Hair Line Solder Shorts for PTH connector and the Hair Line is too tiny that X-Ray and ICT could not detect.Any suggestion on how we can resolve or at least detect this upfront.
Electronics Forum | Thu Apr 14 11:03:51 EDT 2005 | patrickbruneel
All possible causes aside, how can a dead short pass your ICT unless the connector is not probed.
Electronics Forum | Fri Apr 15 13:46:50 EDT 2005 | steve
They can be expensive and if your using water soluble chemistry you will have to immerse the pre-form into flux. Asking the vendor to provide flux with the pre-form I believe it would dry out prior to use.
Electronics Forum | Thu Apr 14 12:48:54 EDT 2005 | russ
boards greater than this spec. can cause latent failure, Do not confuse no-clean assembly materials (nocleaning required) vs. clean chemistries that must be cleaned. You do not want ionic contaminants on your products.
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you