Electronics Forum | Mon Jun 27 03:40:44 EDT 2011 | samsim
Other areas you can focus 1) Find out alternative chemical and solder materials for lower cost. 2) Set high power consumption machine (such as Oven and wave) to idle mode when not running to cut electrical consumption. 3) Reduce the used of N2 gas.
Electronics Forum | Tue Jun 28 07:21:49 EDT 2011 | joe302
i posted on here last week about a manual and received a reply and the manual. THANKS again Alan. was very helpfull. Now i find i am in need of the schematics. can anyone help?
Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Mon Jul 04 20:10:05 EDT 2011 | rickysanchez
1.The bubbles appear only after the oven curing.before curing no bubbles encounterred. 2.The bubbles were very small, and can be found around the die in between the die and the epoxy. 3.Curing time is 150 degC for 4 hours.
Electronics Forum | Fri Jul 08 02:00:20 EDT 2011 | promax
Hello, i´m trying to do a program to convert a text file from Altium to Topaz-X files. But i dont have any information about its format. Can someone help me Thanks
Electronics Forum | Mon Jul 11 08:35:54 EDT 2011 | scottp
I see bare copper on top of some of the leads. Maybe that's normal and acceptable, but I would look at the underside (solderable surface) of the leads on some bare parts to make sure they're properly plated. Poor solderability can be one cause of v
Electronics Forum | Wed Jul 27 13:41:55 EDT 2011 | mmjm_1099
I am looking for one in the Wisconsin area. I have a GSM1 I purcahsed and need sonmeone to come in get it up and running so I can resell it on the used market.
Electronics Forum | Thu Jul 28 20:19:14 EDT 2011 | edwaterfall01
Ex UIC FE (15 years) available for service work on all GSMs. If interested we can arrange to discuss further.
Electronics Forum | Thu Jul 14 22:02:12 EDT 2011 | datech
Hi we had just purchase a used vitronic reflow oven, can anyone know to assist us on the user ID (system) for default password. also we need to have the manual and both electrical and operation thank you in advance vincent low
Electronics Forum | Mon Jul 18 23:13:07 EDT 2011 | datech
hi, we need the electrical and operation manual for the oven, can anyone assist us on this thank you in advance best regards vincent low