Electronics Forum | Fri Dec 01 17:18:31 EST 2006 | Jim
Doing a head-to-head comparison is best. Use the same boards with the same defects to compare programming time, inspection speed, amount of inspection types you can program for and of course defect detection. Finding the defects that occur in your pr
Electronics Forum | Thu Nov 30 16:10:05 EST 2006 | Hussman
Wow, why all the anger? This gap you guys are talking about is measured as "G" in IPC/EIA J-STD-001 (Chunks was there, but she failed to read the fine print). And almost all parts that measure G follow Note 3 which states "Properly wetted fillet s
Electronics Forum | Tue Nov 28 21:16:17 EST 2006 | davef
J Rose at EMPF says: The introduction of no-clean solder fluxes in electronics manufacturing has given rise to greater levels of solder balling simply because the opportunity to remove them in the wash process does not exist. They are typically cause
Electronics Forum | Thu Jan 04 08:33:08 EST 2007 | davef
You cannot determine foil thickness from its weight per area, because of the significant variation in the density of electrodeposited [ED] copper. But people don't care. They do it regardless. (oz/ft2)||(mils)||(mm) 1/2||0.7||17.8 1||1.4||35.6 2||2
Electronics Forum | Tue Jan 09 13:54:10 EST 2007 | jdengler
Hi All, I'm having a problem with a Fuji GP-341. It has squeegee pressure control using a TEAC TD-320A comparator. I cannot get it to measure printing pressure. On the TD-320A it normally reads "2512" then flips to "oFl4" then back to "2512". If
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
Electronics Forum | Sun Mar 18 23:01:11 EDT 2007 | diesel_1t
Hi there, I want help on the following issue. Where I work, we place a component QFP 256 terminals (20 mil pitch)from hitachi (renesas), we use a MPM UP-3000 screen printer, IP-III placement machine and Vitronics 8 zones reflow Oven. lead plating
Electronics Forum | Tue Apr 03 08:02:05 EDT 2007 | itaig1
I have the manual for this machine and the programs I am after allow me to connect the machine to a PC via an RS232 interface to allow upload and download files to/from the machine as well as an optimiser. We have had the machine for a while and is o
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Fri May 04 01:34:07 EDT 2007 | dsd
Your Head 1&2 have Chucks, is Head 3 a Chuckless Head? The Chuckless Head or Precision Head is the intended Head for use with the Centering Station only. Using Head 1 & 2 is not good as there is too much nozzle play. In your Machine Configuration is