Electronics Forum | Thu Feb 06 17:16:41 EST 2003 | gregp
I do not know about the cost issues but as I recall the tolerances are tighter on bulk components and this usually means higher cost. I cannot find my bulk feeding summit information but these links give you some idea what was discussed. I don't kn
Electronics Forum | Fri Mar 21 20:21:41 EST 2003 | Grant
Hi, I can verify that, and we have done 2 or more reflows with prototypes, using vapor phase reflow, and because there is no oxygen, the result is good, and you cannot tell the difference between the first reflow, and the 3rd. We are getting a vap
Electronics Forum | Sun Mar 23 16:25:39 EST 2003 | testing
Hi, If a PCB board is scrapped because it contains faults that cannot be repaired or it has been damaged, we currently quarantine them for a period of time. Once this period of time has passed the boards are then disposed. Does anyone know of an
Electronics Forum | Wed Apr 30 08:00:33 EDT 2003 | pjc
Jason, In Transmission AXI the entire solder joint volume is imaged, not just a slice (no missing information) as with Cross-Section. Also, there is no signal loss from mechanical or digital image reconstruction (highest contrast and edge strength).
Electronics Forum | Fri Apr 25 17:47:23 EDT 2003 | kenBliss
Pete I can fully understand the inter-departmental problem your dealing with. A couple of simplistic thoughts since your only dealing with pennies. You cannot afford to run out or the parts you are dealing with or you will have thousands of dollar
Electronics Forum | Mon Apr 21 06:26:28 EDT 2003 | Grant
Hi, We have a SMT production like, however we have very little experience with through hole assembly. We design everything to be completly SMT based, however connectors are the only part of our product that still requires through hole assembly. Cur
Electronics Forum | Thu May 01 13:56:45 EDT 2003 | kmorris
Dave: After the stencil was made with apertures for a connector on this PCB, it was discovered that the connector would have to be handsoldered after SMT reflow. If the solder deposits are left to reflow on the pads, it makes it difficult for the o
Electronics Forum | Fri May 23 16:05:20 EDT 2003 | davef
I hesitate to go very far with this, since Brian cannot defend himself. He's napping. A thumbnail: * We're talking about the ability to click on a link for an email address that someone included in a posting, have that link pop-up an email dialog,
Electronics Forum | Wed May 28 17:45:03 EDT 2003 | testing
Hi All, I have currently got several AOI Machines that I want to collect data from for some SPC analysis. However, can someone please guide me to what I can and should measure with this equipment such as Cpk etc, and if possible provide some method
Electronics Forum | Tue Jul 15 12:55:41 EDT 2003 | sam
We are contract manufacturer for SMT and complete products. There were cases that we charge our customer for the set-up costs, mainly for some trial and evaluation work on our SMT line, especially when mass production order is not confirmed yet. F