Electronics Forum | Mon Feb 23 03:10:05 EST 2009 | daan_terstegge
I'm looking for carton boxes for SMT-reels, as on this picture: http://img.photobucket.com/albums/v288/drone67/DSC00464.jpg They used to be supplied with parts from Philips, but they don't seem to make these anymore.
Electronics Forum | Thu Feb 19 13:39:51 EST 2009 | tedel
Yes, I called Fuji as well!! I guess we're all in the wrong buisness... Received a reply from Biral Lubricants in Norway, they state the following... "We have established our own warehouse in St.Petersburg, Florida and handle presently all inquirie
Electronics Forum | Wed Feb 14 22:51:42 EST 2018 | leadthree
How you pack & ship your board level assemblies? I mean assembled PCB modules without housing etc. We often have small assemblies (cigarette box size) in the $5-15 range. We put them the (dreadful) red bubble bags and then on carton trays with carto
Electronics Forum | Sat Feb 17 04:39:29 EST 2018 | leadthree
I ship mainly TNT. They handle the boxes very careful, because it said so on their website ;-) But seriously, we use quality cartons and I feel safe. We use a divider packing and the modules are rather loose since we use it for a few different modul
Electronics Forum | Thu Dec 21 19:24:25 EST 2000 | Alejandro Rodriguez Gallegos
Hi Sorry my poor english We have some problems with some componentes 0402 we recived by the manucterer oxide in the tape reells exactly in the bottom side to the reel I think the root cause is the oxide in the tapes rells What do you think? And ot
Electronics Forum | Fri Mar 19 13:18:03 EDT 2010 | deanm
Regarding your question about buying equipment to vacuum seal the MBBs, according to the IPC/JEDEC standard, "Full air evacuation is not needed or recommended; light air evacuation will reduce the packaging bulk and enhance carton packing. Excessive
Electronics Forum | Wed Sep 23 14:30:05 EDT 2015 | deanm
"...air evacuation is not required (Figure 3-5). Light air evacuation may be used to reduce the packaging bulk and enhance carton packing (Figure 3-6). Full evacuation shall not be used as it will impede desiccant and HIC performance and possibly lea
Electronics Forum | Wed Sep 22 16:48:40 EDT 1999 | C.K.
Question for you SMT guru's out there. What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: 1.) Custom b
Electronics Forum | Wed Sep 22 16:51:05 EDT 1999 | C.K.
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
Electronics Forum | Thu Sep 23 10:20:58 EDT 1999 | Earl Moon
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
