Electronics Forum: centroid data (Page 1 of 12)

gerber converter to centroid

Electronics Forum | Fri Oct 20 14:35:44 EDT 2006 | pms

We use CircuitCam for MyData off-line machine programming, it's wonderful and I don't know how we did without it. But, it's pricey.

x-y data generation

Electronics Forum | Wed Jul 06 09:51:23 EDT 2005 | Jack

Doug, It always seems easier to fix one or two problems by eye at the time. The real problem comes when the customer wants the same board run again later. You're okay if you saved the corrected placement routine, but if you end up moving the job t

Convertion Gerber to P&P data

Electronics Forum | Wed Jan 11 10:12:23 EST 2006 | ratsalad

I've used an old version (maybe 7 or 8 years old) of GC-Place to convert gerber to centroid data. It is semi-automatic. If I remember correctly we'd start by selecting the pads for the largest components first. The software would find matching gro

Convertion Gerber to P&P data

Electronics Forum | Thu Jan 05 13:29:43 EST 2006 | jax

Nothing is automatic from Gerber. Gerber is stupid data. (Pads are defined, not components) I think you are looking for Centroid Outputs not CAD. Cad defines the components on the board as well as the board itself. Centroid gives Ref. Desig., X, Y,

Convertion Gerber to P&P data

Electronics Forum | Thu Jan 12 01:07:34 EST 2006 | pavel_murtishev

Good morning Mark, CAM (Computer Aided Manufacturing) products are designed to solve such tasks. You can try CAM350 for example. CAM350 understands different ASCII exported data from different CAD systems. CAD ASCII export contains all necessary inf

Convertion Gerber to P&P data

Electronics Forum | Wed Jun 20 14:34:23 EDT 2007 | pnguyvu

Hi Mark, You can use the software called GC-PLACE to convert centroid, there are alots of SMT process engineer using it. Regards Steve USA STENCILS

what software is out there that will extract XY centroid from gerber data?

Electronics Forum | Sat Feb 04 10:02:53 EST 2017 | mikekeens

GC-PowerPlace from http://www.graphicode.com/ will do this but takes time to get to grips with and can be time consuming depending on the design complexity and the type of data available. Ideally i recommend asking for CAD data as this will contain

what software is out there that will extract XY centroid from gerber data?

Electronics Forum | Mon Feb 24 12:41:18 EST 2014 | mi

Depending on what X-Y centroid / CAD data you need, there are different SW I've used to do the job. If you need PCB gerber "artwork" (rounds, rectangles, lines, squares,...geometric figures), you can use GraphicCode GC-Place & such - load the gerber

  1 2 3 4 5 6 7 8 9 10 Next

centroid data searches for Companies, Equipment, Machines, Suppliers & Information

SMT feeders

Software programs for SMT placement and AOI Inspection machines from CAD or Gerber.


Inspection mirrors for electronic rework and repair.
Selective Conformal Coating System - GPD SimpleCoat

ONLINE IPC Training & Certification
Green Monster Stencil Wiping Rolls

무플럭스 리플로우 솔더링을 위한 포름산 리플로우 오븐