Electronics Forum | Thu Jun 05 14:00:12 EDT 2003 | samaniegocesar
Thank you guys, if you have in stock, used or new, can you send me the price to the next email address please: samaniegocesar@hotmail.com cesar_samaniego@condordc.com Best Regards
Electronics Forum | Fri May 07 11:30:48 EDT 2004 | Mike Cyr
Hi Cesar, If you will contact me directly, I can help to arrange 4790 operations and programming training for you. Please call me directly at Universal Instruments so that I can understand your situation and provide the best possible response. Or E-
Electronics Forum | Thu Jun 05 10:43:51 EDT 2003 | samaniegocesar
Hello to all I need your support, I'm looking a used KME Create servocontroller and the software for Reflow oven of the same line, the part number is: CACR-SR03AB1ERY90 This controller is used in a chipbonding machine BD10 of KME create lines or chi
Electronics Forum | Tue Dec 16 04:20:51 EST 2003 | ex maintain leader
Hi Cesar, I' think is not soo critical, but take cre my 5Y experiences are focused mostly bad designed pcb's on outrunning project wich are transfered to eastern europe or to mini factories in austria. at wery old dek265 I see 45 degrees squeegue
Electronics Forum | Fri Jan 23 13:41:30 EST 2004 | samaniegocesar
Hello Ta all!! I'm Cesar Samaniego From Mexicali Mexico. Some of you guys know some Panasonic KME service center in Mexico country?? Some times I have the necesity to take some programing training of KME equipment like SP10P-BD10-CM82C-CM92P, If yo
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,
| 1 |
