Electronics Forum | Mon Nov 01 08:44:38 EST 1999 | Clifford Peaslee
We do try to push the new thing for as long as we can, but there is a limit. thanks, Cliff
Electronics Forum | Thu Oct 28 23:04:34 EDT 1999 | Micah Newcomb
Has anyone out there tried placing BGA's with a Fuji IP2? Fuji says flat out no way but I think we can if we get them in T&R.
Electronics Forum | Fri Oct 29 10:44:35 EDT 1999 | Doug Nebel
We have placed them before. You can only inspect the perimeter, but with the larger pitch in wasn't a problem. We also picked off matrix trays, but the BGA's we did had no center array. But if that type are on T&R it should work as well.
Electronics Forum | Sun Oct 31 19:36:19 EST 1999 | JC Leigh
Can you please give me a pointer on where to find the component package orientation standard in the IPC? I think we'll work up a spec sheet for the folks in purchasing and let them handle the vendor side of this problem. Thanks for your help! JC
Electronics Forum | Thu Oct 28 11:11:47 EDT 1999 | Eric Maddy
Is there anyone out there that can get me some info on UMG Technologies equipment or a website I can go to to get some info? Also is there anyone who has used this equipment?
Electronics Forum | Thu Oct 28 11:50:35 EDT 1999 | Dave F
Eric: Royonix 661-257-0303 http://www.royonix.com/umg.html seems to be the US distributer for UMG Technologies' High Speed Axial Thru-Hole Inserter Systems Ta Dave F
Electronics Forum | Thu Oct 28 04:42:09 EDT 1999 | Dubron
Hi, I'm Michael Dubron, french student at University. I'm studying surface mounting technology for a training. I need informations on this topic to make my report. Thanks michael.dubron@caramail.com
Electronics Forum | Thu Oct 28 03:52:19 EDT 1999 | Ron Lahat
Looking for low cost First Article workstation for PCBAs ? The environment is low Volume High Mix PCBA production There is a constant need to do firs article in all three shifts (24 hours) Currently it is not automated, it is time consuming and op
Electronics Forum | Thu Nov 04 21:36:36 EST 1999 | chris
Hi John, Thanks to your reply, just one question is it possible that the solder paste ( flux material )applied to the pads cause the non-wet. regards Chris
Electronics Forum | Fri Nov 05 10:01:04 EST 1999 | Dave F
Chris: You can have more than "one question!!!" Anyhow, yes crappy solder paste can cause non-wetting, but before you go there understand why the paste is wetting some surfaces, but not others. Ta Dave F
