Electronics Forum | Mon May 21 22:15:34 EDT 2007 | seb1970
Does anyone know where i can purchase a frame/stencil adapter for the MPM manual stenciler in Ohio? Preferably a air adapter. And also spare parts? Thank you for your help.
Electronics Forum | Tue May 22 09:37:11 EDT 2007 | jdengler
Hi Joakim, I do not know the QP242 table, but on our GP-341, CP-IV-2 and IP-III we make a plate from plexiglass with milled holes to show where the supports go for each board. This is not as fast as the Gridlock but does not cost nearly as much. J
Electronics Forum | Tue May 22 20:27:34 EDT 2007 | davef
What are the area and aspect ratio of the apertures that clog? When you print, you should be able to fit at least 4 of the mean sized solder sphere across the width or diameter of your smallest apertures.
Electronics Forum | Wed May 23 16:04:43 EDT 2007 | adlsmt
Does anyone have a version of software later than 2.04e_ps? SCS/Speedline will not supply it because the computer is no longer supported. Also, the laser pointer and the auto rail width seem to have removed themselves as options. Anyone know the mast
Electronics Forum | Thu May 24 07:09:04 EDT 2007 | aj
Any advice with using this type of PCB material would be welcome. aj...
Electronics Forum | Thu May 24 07:25:38 EDT 2007 | leemeyer
Does anyone know what the operating system for a 1996 MPM SPM printer is. The hard disk crashed and I need to reload.
Electronics Forum | Thu May 24 08:29:38 EDT 2007 | bgrant
Hi, Must be the time of year. We just went through the same thing, similar year of printer....It was DOS 6.2
Electronics Forum | Tue May 29 11:59:53 EDT 2007 | leemeyer
Thanks for the info. I have installed Dos 6.22 and re-installed the SPM software. Now when I boot up I get an "invalid installation" error and the program terminates. Are there other setup issues I need to take care of.
Electronics Forum | Tue May 29 15:52:27 EDT 2007 | ck_the_flip
CURSE BILL GATES! Your next move should be to perhaps reformat the entire hard drive, re-install the software, and THEN try again.
Electronics Forum | Thu May 24 16:59:49 EDT 2007 | pjc
Is wash temp the same in the new washer? I'm thinking that may be a clue. Are you sure nothing else changed, like water supply at all- conditioner? Do you have a supply of DI water?