Electronics Forum | Thu Apr 22 14:27:34 EDT 2010 | peteb
I have a Dynapace 400 series conveyor. How do I make it change direction? Is Dynapace still in business? Thanks for any info you may have.
Electronics Forum | Mon Apr 26 16:02:30 EDT 2010 | markhoch
Are the drive motors DC? Reverse polarity on the motors and switch your photosensors on the entry and exit end. You might have to play with the SMEMA connections a bit, but you'll figg it out. ;)
Electronics Forum | Fri Apr 23 09:13:04 EDT 2010 | kdaglio
for the last couple of days when i power up our quad iv, i get assembler is off errors. i cannot get the machine and the quad align to start. any help is gratly appreciated.
Electronics Forum | Fri Apr 23 10:53:24 EDT 2010 | evertonsanches
Hello Sir, in this situation I recommend you to check and reconect the conectors of Quad Align Board and also of Quad Align Sensor. Everton - Brasil
Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw
Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.
Electronics Forum | Fri Apr 23 17:00:31 EDT 2010 | davef
Hegeman: So you receive these boards in seal moisture barrier bags, store them in a controlled environment, and use them as needed; what is your goal in baking these poor babies?
Electronics Forum | Sun Apr 25 09:10:25 EDT 2010 | sudhir14
Hi, pl. help me , I need details info. on Cp & CPk methodology , how to calculate , how to analysis Sudhir
Electronics Forum | Mon Apr 26 03:00:43 EDT 2010 | fujiphil
Check the following... 1. Set the fiducial reading to SCAN... 2. Clean the half mirror of the fiducial camera... 3. Check the CCD Camera...maybe blown fuse inside. Hope this will help.... Good luck....
Electronics Forum | Mon Apr 26 15:52:11 EDT 2010 | markhoch
If the above recomendations do not help...(I'd try them first) Did you try the infamous "Fuji Fix"? Power the machine all the way down and power it back up. (Rebooting the software)
Electronics Forum | Sat May 08 07:03:31 EDT 2010 | aj
From looking at your images I would say it could be poor solderability on the terminations of the component itself. Can you get your hands on a different date code and try them out?
