Electronics Forum | Thu Sep 02 08:32:18 EDT 2010 | rway
Yes, you are correct. I converted it (tryed to at least) by hand and did not carry by decimal place far enough in converting mm to mil. I double-checked my conversion and confirm 1mm = 40mil. Thanks for correcting me.
Electronics Forum | Wed Aug 11 14:45:46 EDT 2010 | davef
Yes, it OK to mount axial PTH component as radial PTH, if that's what you're asking. * There are no rules for orientation. Pick something and stick to it. We like to be able to read the component value / orientation from the top towards the board.
Electronics Forum | Thu Aug 12 14:17:19 EDT 2010 | mikesewell
You might reduce your panel size, cut it in half and rotate to better utilize your edge clamping/board supports. Tape off your current stencil and see if it improves the print. A new stencil and a little extra handling may be cheaper than tooling.
Electronics Forum | Thu Aug 12 21:06:48 EDT 2010 | ptpaazmi
COLD SOLDER LOCATION U600/U601 Problem : Several XMp3i Rotary swithes were found to exibit intermittent function during a DV build at WNC
Electronics Forum | Tue Aug 24 20:15:27 EDT 2010 | davef
What is ... and how does it pertain? * Location U600/U601 * XMp3i Rotary swithes * DV build * WNC
Electronics Forum | Mon Aug 16 12:27:44 EDT 2010 | mikesewell
Don't have one but have you tried starting with a fresh install of the software, you may want to swap PCs or hardrives to keep your existing setup intact.
Electronics Forum | Tue Aug 17 04:43:57 EDT 2010 | aj
Hi all, Just looking for some advice on SMD push fit connectors. Are most machines spec'd do place these reliably or do they cause problems? AJ...
Electronics Forum | Wed Aug 18 11:12:04 EDT 2010 | davef
So with your mounting frustration in your inability to zero-in on the factors that drive your solder balling, are you thinking that maybe you need to bite the bullet and design a experimental study to help isolate the key drivers to your solder balli
Electronics Forum | Fri Aug 20 06:32:44 EDT 2010 | aj
Hi, I would recommend you trial an alternative supplier if you have the option. I did a lot of trials on the issue and dont have any problems. Contact me off line and I will share details aj...
Electronics Forum | Fri Aug 20 10:07:09 EDT 2010 | dan_ems
Hello, I have the same problem ..., please take a print screen with the profile to see how is made it. Thank !
