Electronics Forum | Tue Mar 27 05:01:32 EDT 2012 | pdl
If you have a way of sending a lump of metal by email please let every one no how. thanks Pete
Electronics Forum | Wed Mar 21 06:13:42 EDT 2012 | sparrow
Hello Hunzo, many thanks for your detailed reply! By the way, I am well familiar with the smell of Galden liquid that is used in vapour phase soldering ovens. Does ADL have the similar smell?
Electronics Forum | Mon Feb 27 08:58:38 EST 2012 | graemec23
Could anyone suggest where I could get a suitable connector for the 3pin oxggen sensor in the attached datasheet? It cannot be soldered. The link in the datasheet to their recommended connector is broken. I want to use a thru hole to mount it. I
Electronics Forum | Mon Feb 27 23:02:55 EST 2012 | ev
We have a TP-11 and this error occurs at the start of the insertion pattern hence we can't run. Any suggestions for correction? Thanks, Ev
Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Tue Mar 06 15:10:03 EST 2012 | thanh
WHY DIDN'T YOU OPTIMIZE WITH FEEDERS MOVE AND NOZZLE FREE. IT WILL PICK AND PLACE 8 PARTS AT A TIME.
Electronics Forum | Tue Mar 06 15:53:57 EST 2012 | acsscott
I did optimize. All it did was change the order or the resistors it picked up and placed, and changed the order of the LED's that it picked up and placed. Still only four parts at a time.
Electronics Forum | Thu Mar 15 21:57:41 EDT 2012 | daniel26
On your mount data it has to go 8,7,6,5,4,3,2,1 once it goes to a higher number then the previous it has place and start over try that out
Electronics Forum | Sun Mar 25 15:17:38 EDT 2012 | duchoang
I used Topaz x and X2 long time ago. I might be wrong, but let's check the thickness of components and the camera light recognizing setup for each part. (?). They may be too different to be optimized for simultaneously pick-up and place.
Electronics Forum | Wed Apr 04 21:34:26 EDT 2012 | acsscott
Setting the 1206 resistors and the LED to the same height didn't make it load all 8 heads before it moved over to place the parts. Any other ideas?