Electronics Forum | Tue Oct 07 08:44:49 EDT 2014 | emeto
Hi, 1. I will run the board on the mesh if single sided. 2. For double sided board, I will try stiffeners. 3. If stiffeners don't work, then you have to create a handling fixture(holds the board and has enough openings to let the air flow to the PC
Electronics Forum | Wed Oct 08 11:15:20 EDT 2014 | wavemasterlarry
Listen! I generally just bend them back straight. Kinda like a them knew I-fones! Ha! I like my flip fone. nothing buttton, but that's what fones are for - calling people.
Electronics Forum | Tue Oct 07 10:18:23 EDT 2014 | emanuel
Hi everyone, Any idea where can I purchase a nozzle for 3535 LEDs in general or Cree XPE specific, for a Philips Topaz/Emerald machine?
Electronics Forum | Mon Oct 27 09:44:01 EDT 2014 | cbeneat
Thanks for the replies. It looks like the fuse clip itself is the problem, it seems the "coating" is a chrome like finish over a copper, I believe, anyway I hit the legs with some Emory cloth and inserted them in the board and they were fine after r
Electronics Forum | Mon Oct 27 16:28:18 EDT 2014 | hegemon
Thanks to the OP for the last post, closing the issue. So many times these threads can kind of tire out, and no one ever knows what the solution to the original problem was. Of course, that's the point of these forums. 'hege
Electronics Forum | Tue Oct 28 13:47:49 EDT 2014 | cbeneat
Hedge, Exactly why I posted the last. I read the Forum daily on all machines/issues, not just the ones we use, no telling what you'll pick up along the way:)
Electronics Forum | Wed Oct 08 11:32:11 EDT 2014 | wavemasterlarry
So I got this engnieer that says the boards I waved for him dont pass his flying probe test. What the heck is a flying probe? If it's anything like my doctors probe, I don't want anything to do with it!!
Electronics Forum | Thu Oct 09 05:43:47 EDT 2014 | cspasol
Anyone know the Hexi Reflow Oven (SF-820-LF) Zone Motor Specs?
Electronics Forum | Mon Oct 13 13:24:21 EDT 2014 | rgduval
Deni, Yep, we found that one the other day, too. And, yes, axis mounted is set to 1. We tried setting it to 0, saving, then back to 1 (again, hoping to clear a software flag/fault, if that's what it is). Thanks, ..rob
Electronics Forum | Mon Oct 13 18:15:38 EDT 2014 | ilavu
Hey rob, make sure you do the changer setup. That procedure looks at the fiducials on the changer and adjust the position for nozzle change. It is in system setting. Motor or amp is not easily go bad. I have machine from 92 and never had problem with