Electronics Forum | Wed Feb 28 15:11:45 EST 2024 | emeto
Hello all, I have a flux over components that affects AOI results in reading the symbols on top of it. What would you recommend to minimize this effect?
Electronics Forum | Wed Feb 28 17:07:50 EST 2024 | emeto
Once you warm it up to room temperature, use it or lose it. Paste should always be brought to a room temperature before use. If it is not ready, don't use it.
Electronics Forum | Wed Feb 28 17:20:25 EST 2024 | jdengler
Find out were the excess flux is coming from. See if it can be eliminated or reduced at the source. Lokely coming from something other than SMT assembly.
Electronics Forum | Wed Feb 28 19:34:34 EST 2024 | tey422
I have seen there is flux like stuff dripping off from the exhaust area of the reflow oven onto the board That would be the issue of poor maintenance.
Electronics Forum | Thu Feb 29 04:26:27 EST 2024 | jborrelli76
A spare part due very soon, now to change it out. I think I have to remove the entire right arm...suggestions or guidance WELCOME. Thanks!
Electronics Forum | Thu Feb 29 08:34:13 EST 2024 | mabass888
What is the best machine to assemble spot lights and downlights fully automatically?
Electronics Forum | Thu Feb 29 13:42:53 EST 2024 | mistrthou
I'd be looking at the safety circuit as a whole. Grab a multimeter and make sure you get a full closed loop back to the safety relay, and see if the safety relay itself didn't go bad.
Electronics Forum | Thu Feb 29 17:50:55 EST 2024 | compit
I don't know if it's the same in the XII series, but in the X series the emergency signal also passes through the electronics board on the head, cards in the computer, etc. - through ALL elements of the machine.
Electronics Forum | Fri Mar 01 09:39:08 EST 2024 | dimamalin
We are planning to purchase a new machine for automatic stencil cleaning. If anyone has experience using such equipment, what would you recommend? I appreciate any advice when choosing this equipment. Thank you in advance.
Electronics Forum | Fri Mar 01 13:35:41 EST 2024 | proceng1
Message me. I know a few of the former Service Techs from ACE, depending on your location, they may be available for side-work.
