Electronics Forum | Sat Jul 29 12:52:38 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Sun Jul 30 09:39:50 EDT 2000 | JAX
BIG J, Long time no see, I have only seen this problem as the size of the part increases and reaches the camera's maximum tolerance. Are the parts always failing on a specific side of the machines( next to MTU )? You might want to get in touch with O
Electronics Forum | Sat Jul 29 12:51:34 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Sat Jul 29 12:51:28 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Sat Jul 29 12:50:31 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Thu Jul 27 21:08:25 EDT 2000 | Doug Philbrick
A friend of mine just installed his last week. So far he LOVES it, but then he is replacing Zevztech 460's and 570's almost anything would have been better. Ill ask him if he minds you calling him. If he doesn't Ill send you an email
Electronics Forum | Thu Jul 27 14:48:26 EDT 2000 | Bob Barr
Is Mil-I-46058 still an active spec or has it been obsoleted by the Feds in favor of IPC specs? I have an internal process document that is based on IPC requirements, but a customer wants me to use their specs that are based on the mil spec. I am ho
Electronics Forum | Thu Jul 27 08:38:36 EDT 2000 | Wolfgang Busko
Hi Jason, a couple of questions: What�s the pitch? Did you change direction the board is going through the wave and what happend? How about the design abnormalities for those 4 pins, thermalreliefpads or whatever? We had problems with 2mm pitch and
Electronics Forum | Thu Jul 27 11:47:02 EDT 2000 | Jason
i've rotated the board with the same result. What are soldertheif pads. I'm new to wave soldering and this is another new one on me. What did you use? where do you put the pads? please explain as much as you care to...also my leads are 1mm and th
Electronics Forum | Thu Jul 27 11:47:15 EDT 2000 | Jason
i've rotated the board with the same result. What are soldertheif pads. I'm new to wave soldering and this is another new one on me. What did you use? where do you put the pads? please explain as much as you care to...also my leads are 1mm and th