Electronics Forum | Wed Sep 08 23:45:19 EDT 1999 | kyung sam park
I wonder to knock this site with this question? Are there some body have applied 6 SIGMA TOOL to improve the smt process or etc. especilly smt process is better. I want to hear the difficulties to apply this tool. and experiences. I dont't care go
Electronics Forum | Wed Sep 08 20:38:06 EDT 1999 | Barbara
I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Thu Sep 09 11:28:20 EDT 1999 | Larry Koens
| We are currently quoting several vendors on the through hole portion of a new mixed technology production line. Unfortunately, I have not been able to find much information about NEA's cabaility, quality, or service. Any comments or references w
Electronics Forum | Wed Sep 08 17:28:11 EDT 1999 | Earl Moon
| | Has anybody have any experience with Top placement of BGA's. GLue descretes on bottom and then wavesolder.? | | | | | | | Hi Chris, | Why don't you process a double side reflow and use selective wave fixture for wave process. The process w
Electronics Forum | Thu Sep 09 11:17:59 EDT 1999 | Glenn Robertson
| Has anybody have any experience with Top placement of BGA's. GLue descretes on bottom and then wavesolder.? | | | Chris - This is a common practice. Just remember that BGA solder joints are especially susceptible to secondary reflow damag
Electronics Forum | Tue Sep 07 03:52:50 EDT 1999 | Wolfgang Busko
| My company is starting a prototype. The chips that will be used appear to be very sensitive. The vendor part number is Neta-40-2. | My question is what solder temp should be used for this part? | Any advice is appreciated. | THX. | | If you�re un
Electronics Forum | Mon Sep 06 20:22:03 EDT 1999 | Devon Richards
Please excuse my ignorance, I am a brand new EET student. Can someone please tell me how to identify smt components on a pcb? ie: which is a resistor, capacitor etc, and what do those tiny numbers mean? My digital prof. did not know!!! Thanks in a
Electronics Forum | Fri Sep 03 14:22:39 EDT 1999 | Mariscal
I have been running a Stoelting Aquaeous machine and has been performing very well however. the maintanance dept cleaned using the descaler and now we are seeing boards with a removable thin film. We are going to to drain all the water and change all
Electronics Forum | Fri Sep 03 14:29:29 EDT 1999 | David
| | Where do I find information about Create SMD machines? I don't know that is that Create real name, but it suppose to be manufactured by Matsushita. | | | | | Reijo, | Listed below is the link you are looking for. | http://www.p
Electronics Forum | Thu Sep 02 21:02:55 EDT 1999 | Paul Wareham
We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes?
