Electronics Forum | Sat May 09 13:49:03 EDT 1998 | EFData
Awhile back, I remember seeing some postings regarding solderability of Alloy 42; unfortunately, at that time, it wasn't a concern of mine but it is now. There was a gentleman from TI who seemed to do some extensive research into the matter; do any o
Electronics Forum | Fri May 08 16:33:46 EDT 1998 | Chrys
| As usual, we are faced with too many components and not enough board on a new design. Does anyone have experience wavesoldering .025" pitch TSOPs on the bottom side? | Any advice is appreciated. | Greg Sounds scary, particularly from a reliability
Electronics Forum | Thu May 07 18:30:38 EDT 1998 | Peter
We just purchased Mitron/GR Software's CB97. We have Universal's 4790 and Contact's 3AV machines. Both these machines part libraries are in binary format and their respective software packages cannot export out into ASCII. Has anyone out there discov
Electronics Forum | Thu May 07 22:13:10 EDT 1998 | Wayne
| Sorry for the confusion. For now there is but one | forum, and that is this SMT Forum. Everyone is | welcome to post any technical issues related to | pcb design, fabrication, and assembly, of which | capital equipment is an integral part. Cunli
Electronics Forum | Wed May 13 06:30:44 EDT 1998 | Wayne
| | Me thinks Wayne and Pete must be salesman! Duke: As for me you're right, but I think we are all salesmen and are selling ourselves everyday. Some of us better than others! Spent my twenty years in manufacturing before becoming a representative.
Electronics Forum | Thu May 07 15:56:43 EDT 1998 | Terry Burnette
80ppm). The CTE of your board and solder joints will typically be 18-22ppm. We have seen cases were the coating fills the gap between the component and the board, then during temperature cycling the coating expands to the point of breaking the solder
Electronics Forum | Mon May 04 22:42:46 EDT 1998 | Phillipf Hunter
Okay, Fuji MTU4 experts...I need a precise way to determin the X-origin and Y-origin of the tray plates. The center of the S-nozzle referenced to the plate corner is very difficult to EXACTLY measure. I need accuracy to pick small QFP28's - otherwi
Electronics Forum | Fri May 22 15:39:59 EDT 1998 | serge
good morning sir i m Belgium and i was responsable for SMT training and maintenance for Alcatel do you believe that i can help you??? | We are just starting out with SMT. I need any and all the information you have. We are looking to start a sma
Electronics Forum | Mon May 04 21:35:25 EDT 1998 | Dave F
| We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line. Denis, You should pursue the following SMTNet thread on this topic: Posted by Igor Kostyuk on April 22, 1998 at 16:57
Electronics Forum | Mon May 04 16:17:04 EDT 1998 | VICTOR VELANDIA
WE HAVE : PRESS DANLY 89 P.S.I. TON. 5 STROKE 5 IN DAYLIGHT BED TO SLIDE. 11 IN. DIE SPACE. 19 X 19 MODEL. A 34851. SERIAL 93S - 9575 - 01 YEAR 1996 INCLUDING | TABLE AND P.L.C. PERFECT STABILITY
