Electronics Forum | Mon Aug 16 12:23:17 EDT 2004 | soease
Thanx a lot for advice... My only question is: did you had troubles with prehaeating of the boards? I heard it was the only critical point due to chosen technology, infrared preheat (if it's still IR). I allready checked Vitronics Soltec and IBL,
Electronics Forum | Mon Aug 16 21:29:09 EDT 2004 | davef
Peter Please remove the two pirate software and the three job posting threads from the forum. The longer you leave junk like that on the forum, the more that it become acceptable. Those posting have no business remaining where they are. I have
Electronics Forum | Tue Aug 17 12:05:27 EDT 2004 | rlackey
Hi Bernard, Sorry mate but it sounds like it's the Hard Drive ageing - we are seeing this more frequently on our older machines. Hope you've got the install disks & part library/program backups as they don't always like being ghosted. Hope I'm wro
Electronics Forum | Tue Aug 17 11:31:39 EDT 2004 | Cal
Hello All- I need to replace my Foam flux aerator in my wave soldering machine and need a source. The "Stone" Size is 38x25mm @ 3um. If any one has a source thanks in advance. OBTW- this wave not a "Name Brand" machine (i.e. Eltrovert). Cal
Electronics Forum | Tue Aug 17 11:44:19 EDT 2004 | rlackey
Hi, does anyone have any real experience in using the following AOI systems (including opinions on support)? Cyberoptics Flex Agilent SJ50 MVP Supra Landrex Optima (Teradyne) Please fight the urge to pass comment or point out the error of my ways i
Electronics Forum | Tue Aug 24 04:35:33 EDT 2004 | rlackey
Hi Mike, Thanks for the comments. We are upgrading our post reflow inspection - primarily solder joint inspection, and capable of keeping up with a maximum of 80K components an hour. Solder paste inspection is currently carried out by our prin
Electronics Forum | Tue Aug 17 13:24:47 EDT 2004 | blnorman
We have parts that have electroplated tin over nickel. The mfg. assures us the minimum thickness of the tin is 5 microns. Cross sections have shown many instances of 1 micron and pits that go down to the nickel barrier layer. A request for thicker
Electronics Forum | Thu Aug 19 16:50:39 EDT 2004 | davef
The best way to reduce change-over time is to: * Buy lots of feeders * Limit the number of part numbers available to design engineers * Bar code feeders to help verify proper machine setup We know of no such software. There IS software that recomme
Electronics Forum | Thu Jan 05 15:34:55 EST 2006 | Joe Wesley
Electrovert does not seem to be cheaper. Still about 30K more than the Delta. We are investigating too, we are concerned about the dross build up and flow design in the electrovert. The Soltec Machine seems to have less of an issue and maintenance ap
Electronics Forum | Tue Jan 10 14:56:11 EST 2006 | greg york
Worked with Soltec 6622 with Leaded and Lead Free and is a very capable machine with some good knowledgable engineers to back it all up. Not seen a Nousstar yet in the UK nor a Lead Free Electrovert either thinking about it Greg York Technical Sales