Electronics Forum | Thu Jan 19 19:43:38 EST 2023 | smtusa
How does the Yamaha iPulse line compare to the Assembleon MG1? My friends had amazing experience with the MG1 and prefer them. I have never seen an iPulse in person. The heads and software look very similar between the two machines. The M2 seems
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Sun Jan 22 20:53:01 EST 2023 | proy
We reuse ESD bags as much as possible and customers are satisfied - however they seem to accumulate here! I have boxes of used ESD shielding bags which are too good to scrap and can be reused. I need my space, so you pay shipping and I will send the
Electronics Forum | Mon Jan 23 12:26:55 EST 2023 | poly
I'm looking at some Pillarhouse and Juki machines used. Does anyone have a strong preference on selective soldering brands? What's the life time on machine? Is buying a 10 year old machine a waste of time? What are you doing for nitrogen? I'm current
Electronics Forum | Mon Jan 23 18:14:26 EST 2023 | emeto
Try to stay away from this process in general. I have worked with different brands and all of them have some pros and cons.It is a lot to maintain and I am not sure if it will be faster. Repeatability of these machines is very hard to sustain. You sh
Electronics Forum | Tue Jan 24 11:07:41 EST 2023 | poly
Emtimov, what are you using instead? Hand soldering? Is the repeatability due to lacking bottom side fiducials or is the process just inconsistent? We've got a few connectors, something like 20 jacks with 3 pins each on some of our products. Our ma
Electronics Forum | Tue Jan 24 11:49:11 EST 2023 | dontfeedphils
"Try to stay away from this process in general. I have worked with different brands and all of them have some pros and cons. It is a lot to maintain and I am not sure if it will be faster. Repeatability of these machines is very hard to sustain. Yo
Electronics Forum | Tue Jan 24 12:39:24 EST 2023 | linux
Hello MagyarT, Software that Combines data from Kohyoung AOI,SPI and panasonic assembly machines YJLINK conveyors to track back quality root causes of defects -See real-time OEE on your panasonic lines at each location -Drill-down on SMT bottlenecks
Electronics Forum | Tue Jan 24 21:29:06 EST 2023 | stephendo
What about nitrogen purity? Erza won't say anything other than you need 99.999% pure nitrogen. We are looking at another company that says the same. At a previous place we switched from dewers of liquid nitrogen to a single pass filter. I could see