Electronics Forum | Wed Feb 07 15:31:05 EST 2024 | proceng1
We have a few custom made fixtures that use a flat disc like that and they are spring loaded. For our "homemade" fixtures, we generally use screws stocking up in the tooling holes that are cut to only stick up approx .050 on an .062 board, so there
Electronics Forum | Thu Feb 08 05:54:43 EST 2024 | 1_manuel
Thank you for your response! I think, the labels seem more elegant and offer the flexibility of being reversible if the labeling isn't satisfactory. However, the punch numbers themselves are also a viable solution, so thank you for that suggestion
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag
Electronics Forum | Fri Feb 09 14:28:08 EST 2024 | redspare1
Yes, I have ran into this. They won't even sell you a screw unless you give them money to "register" Trying to start for the lowest cost. I see the DEK could be harder to learn as a new person. Yes, self calibration would be great! Thanks everyone f
Electronics Forum | Tue Feb 13 15:03:51 EST 2024 | erikfriesen
I'd like to do some drive imaging on my old windows equipment for backups, mainly boat anchor prevention. Heller, CP45, DEK, various shades of XP embedded. There aren't many good options that I'm finding, for sure not in new software. Any ideas?
Electronics Forum | Wed Feb 14 17:35:16 EST 2024 | davef
SMTnet is been under DoS attack. Our programmers believe they have both a short-term and a long-term fix. Fingers crossed. You can contact me by clicking the link below my avatar just to the left. SMTnet apologizes for the inconvenience, recognize
Electronics Forum | Thu Feb 15 18:35:10 EST 2024 | prestonames
Hi Mahmoud, I hope you were able to find a solution for your project! My company recently purchased an ASM Eagle Xtreme Gold Wire Bonder and we have been unable to locate the manual. Is it possible to share the manual that you have over email? Pleas
Electronics Forum | Fri Feb 16 13:56:15 EST 2024 | redspare1
Acronis is the way to go and the cost is reasonable. https://www.acronis.com/en-us/products/true-image/ You install this on a modern windows PC, make a bootable USB or CD-ROM. Then boot your old computer and save to USB or hard drive. You can also sa
Electronics Forum | Fri Feb 16 14:06:49 EST 2024 | redspare1
You will need an old version of acronis. I think 2014 uses 512mb ram. Just move the machine drive to a newer computer that has an IDE slot. IDE can also do CF with an adapter. You're basically running an PC with nothing in it, just booting acronis,
Electronics Forum | Sun Feb 18 03:27:56 EST 2024 | erikfriesen
You might consider buying a machine on eBay. I found a replacement the other day that came with xp. I think where it gets tricky is if you have the winkic software installed, as it is 16 bit software and seems to break on newer xp versions. There ma