Electronics Forum | Wed Aug 30 08:06:45 EDT 2006 | scombs
The reason I asked earlier about Gridlok is that we are using the on 2 Dek Horizon printers (since Jan 06) with edge clamps and they work well. We run them in Auto mode so they conform to the board at each print so I do not have to worry about the op
Electronics Forum | Wed Aug 30 10:42:42 EDT 2006 | chrisgriffin
I would recommend the UP2000 HiE. This would more than handle what you have describe. If you have a lot of warped boards, the side clamp retro might be for you. I haven't had much production experience with the grid lock, but I know of several pe
Electronics Forum | Fri Sep 01 13:41:49 EDT 2006 | fastek
Bradley...Bradley...don't get your panties in a bunch. I have been a stocking dealer in this business way ...and I mean way before you ever uttered the words Surface Mount. How long have you been in this business? 3 years? Keep trying to sell
Electronics Forum | Fri Sep 01 15:28:42 EDT 2006 | Hussman
H ilarious. E ven tho I don't come here much, it's the same old thing. R eplayed questions, answered by self righteous people. B ut several people told me to check out this thread. P erhaps they are right. A lthough it�s the same old people banterin
Electronics Forum | Fri Sep 01 18:59:40 EDT 2006 | chrisgriffin
Fastek- From the sound of the attitude, you must be competition. And trust me, we do much more than clean them up and paint. How about you? But thanks for the sarcasm. And when you've refurbished a hundred MPM's, you tend to become an expert.
Electronics Forum | Thu Sep 07 13:48:58 EDT 2006 | cardinal
Rick, I didn't mean for this to turn into a big thing thing but a couple of points. 1. I have in this business for over ten years. 2. Speedline sells refurbed units for over $75K 3. If you think it is "BS" come to my facility and check it out. 4. I
Electronics Forum | Thu Sep 07 14:49:18 EDT 2006 | C.K.
Sr. Tech. It's a fancy way of saying that he'll look into how risky it is to buy a used piece of equipment from him. We have a new guy like that here at my place of employment. He wears a necktie (when it's not required) and then talks slowly and
Electronics Forum | Thu Sep 07 22:09:09 EDT 2006 | Doug Eidle
Hi Sr. Tech, Please excuse C.K. He obviuouly has something virulent for breakfast. I am talking about knowing exactly what you are buying and all the associated costs and potential costs. You are making a value judgement, is the machine worth the
Electronics Forum | Tue Aug 29 11:22:12 EDT 2006 | yuceltemel
Dear Bruce, We had the same problem in the same condition. Every compnent and the PCB (OSP) has changed as lead-free and we need to solder them with SnPb. For solution we have increased the flux amount applied on PCB and the pre heat zone temper
Electronics Forum | Wed Sep 06 17:13:17 EDT 2006 | Board House
PB-free Hasl was not mentioned due to the following: 1)Equipment Convertion at the PCB Manufacturing side is expensive. 2)You are subjecting the PCB to Higher Temps than Std. solder. 3)Most PCB Houses are not going to invest in Two Hot Air level