Electronics Forum | Thu Oct 06 11:18:47 EDT 2011 | tpappano
That message is what you get if for example, if you press "stop" while a board is being placed. While "interrupted" you can for example, press "exit", go make adjustments to mount data or whatever, return to "running", then the board program, then p
Electronics Forum | Tue Oct 04 20:18:17 EDT 2011 | denmark
Sir *We are using "HOT BAR SOLDERING" we are bonding "FFC" and "PCB" at 0.5mm pitch. Machine settings: Heating Temp. 310º, Colling Temp. 190º Delay Time 1sec We also using "BECKLITE" as Soldering Jig that can resist up to 400º. We are using 1 is to
Electronics Forum | Sat Oct 01 11:48:20 EDT 2011 | fishingfool
whitewing, I hate to break it to you but this is standard procedure for equipment providers. When he bought the lens he was told of the policy and yet he continued with the purchase. In case you didn't know Yestech does not charge for after wa
Electronics Forum | Mon Oct 03 09:26:08 EDT 2011 | kahrpr
Hate to break it to you but 10k to 15k is becoming more common than you think. On the flip side companies biggest competition is becoming there own used equipment. Going out of bushiness because of slow sales is not very appealing either. Also in the
Electronics Forum | Mon Oct 10 15:07:18 EDT 2011 | kahrpr
An extraction system is not a good comparison. The extractor itself is not where they make their money. It’s off of the consumables filters etc. Aois and other larger capital equipment there is no other income stream after the sale other than a few p
Electronics Forum | Mon Oct 10 15:21:28 EDT 2011 | spitkis2
In my opinion, YesTech or any other company is not obligated to spend days or even hours on the phone with a 2nd hand end user. If it takes days (paying customer or not) they need someone from the manufacturer to be on the shop floor. YesTech c
Electronics Forum | Mon Oct 03 15:13:00 EDT 2011 | tombstonesmt
It sounds to me that it's a heat transfer issue. The solder is only bonding to the lead on not the barrel correct? Does your selective solder equipment have any type of heating source? Can you "dwell" on that particular joint? On some of our products
Electronics Forum | Mon Oct 03 16:02:55 EDT 2011 | artposada
The machine does not have pre-heating feature. I'm soldering a six-up panel...I've tried putting them a an oven and letting them soak for 20 mins or so at a low temp. But by the time I placed the panel in the machine and manually fluxed the top sid
Electronics Forum | Wed Sep 19 12:27:56 EDT 2012 | proceng1
Are you sure that you are getting adequate nitrogen flow up through the cap? If your pump isn't seated properly, you may have nitrogen escaping. Also, I have two different height nitrogen bases. The shorter one does not allow as much gas to escape
Electronics Forum | Thu Oct 20 19:13:21 EDT 2011 | eadthem
When you get in to a 30 spindle lightning head or the dual and single beam 7 spindle flexjets from UIC, there generally really solid machines. The only flakeyness we have is with a GC120 (4 beams in 1 box). and of that most of the issues are purely b
.gif)
