Electronics Forum | Mon Aug 31 14:45:37 EDT 2020 | SMTA-64387994
Can anyone provide any insight to an appropriate way to apply a Gage R&R study to an x-ray inspection machine? We have a Vitrox V810 S2EX machine that we would like to perform a measurement system analysis on. What methods do you use? Which type of G
Electronics Forum | Mon Aug 31 19:15:36 EDT 2020 | dilogic
We have GSM2 with FlexJet heads (an older one). There are 7 sensor amplifiers (with LED indicators) for touchdown detection and one for z-safe detection which is of a different type (with numeric LED indicator). I can't find anywhere what the right n
Electronics Forum | Sun Sep 06 03:24:31 EDT 2020 | rsatmech
Hi All, We are frequently getting tombstone in an induction component. (0102) There is no paste offset or placement offset. PCB pad design is not as per recommendation. Stencil opening is 1:1 Same part used in two locations and both the locati
Electronics Forum | Tue Sep 08 15:12:56 EDT 2020 | cyber_wolf
I concur with Spoilt on all accounts. If the tombstones are isolated to the same P/N this is an indicator that your process is probably not to blame. At this point you have to try and mitigate the issue. Things to try [if possible] : 1. Try a soa
Electronics Forum | Fri Sep 11 15:58:50 EDT 2020 | majdi4
You haven't communicated what thickness of stencil you are working with ... it's interesting to know..at first, you need to reduce the amount of CAB deposited because with 1X1 stencil aperture size you are depositing an amount important CAB .. so, I
Electronics Forum | Sat Sep 12 02:16:41 EDT 2020 | jmelson
Arrgh, that's an SFA-410ED camera, original subject was wrong. Hello, the down camera on my Quad QSA-30 has gone haywire. It still puts out video, but does not sync to the vision system, the picture rolls horizontally. I have verified the vision int
Electronics Forum | Mon Sep 14 21:31:33 EDT 2020 | dwl
Does the flickering go away once the oven reaches its set temperature? It will draw a lot more current while its warming up then when its running. Are your lights running on one leg of the same 415 VAC circuit? Reflow ovens are mostly resistive loa
Electronics Forum | Tue Sep 15 17:03:18 EDT 2020 | edvardvojvoda
Hello! We have a DEK Horizon 03i paste printer. When we load a new program at change over, most of the time it lost the reference point for the camera axes. After that the fiducials coordinates changed automatically to minus values. The service said,
Electronics Forum | Thu Sep 17 15:21:50 EDT 2020 | lpbro
For height, I start +-2mil usually. For 3mil stencils, my lower limit starts at 1.5mil, upper is 5. If the area is chem ethed, I normally add .5 to the stencil height. My default volume is 60 - 160%. Then print specs are adjusted till I see fit, then
Electronics Forum | Fri Sep 18 15:47:15 EDT 2020 | majdi4
Hello guys , For our SPV machine (Printing machine) , am looking for flexible support pin or some other idea to support PCB during second printing process ( Double side process) . We actually using ( 1: stainless steel support with voids for mount