Electronics Forum | Fri Oct 08 11:09:43 EDT 2021 | proceng1
I am currently running 6 Hamwha/ Samsung machines. I have no experience with the other machine you mentioned. We like our Samsungs. I have SM482, SM421 and DECANs. There are less expensive feeders online. They look pretty much identical and work
Electronics Forum | Mon Sep 27 16:52:48 EDT 2021 | aex
During production the temperatures on the last 3 zones are approx. 20F higher than the setpoint. The other zones are operating within spec. We checked power, I/O, SSR's, thermocouples, and exhaust, but the issue remains. We did not check resista
Electronics Forum | Wed Sep 29 09:57:48 EDT 2021 | zxcvb
I'm attempting to perform power analysis on my target, which operates at 3.3 volts. The average current while running is around 140mA without the resistor. With a 5V power source, I utilized a 10Ohm resistor as a shunt resistor. The shunt resistor w
Electronics Forum | Tue Oct 12 13:03:18 EDT 2021 | cunningham
Afternoon all, Do you use any special surface other that ESD matting when changing over matrix trays? We currently use a earthed wire trolley that we keep trays and MSD bags on and when replenishing stock its carried out on the trolley. Does anyon
Electronics Forum | Mon Oct 25 21:42:26 EDT 2021 | astarotf
thanks for the info. But we do not have the installation discs or the software to reinstall the machine. There is no EXM-9 calibration information or BIOS parameters in the document. We have already exchanged the old battery for a new battery on the
Electronics Forum | Tue Oct 26 15:47:09 EDT 2021 | astarotf
Thanks Deni for the document, it is very valuable. I put the configuration that the document indicates to the machine and still the machine does not proceed to execute the SO / 2. After configuring it, we got these messages that I share in the foll
Electronics Forum | Tue Oct 26 17:30:36 EDT 2021 | dilogic
Messages indicate bad battery on EPC-5 CPU board, not SYS68K CPU-30. You have to fix that first. What kind of hard disk is installed? EPC-5 boards support small disk sizes, so sometimes , if larger disk is used, users "trim" reported capacity to lowe
Electronics Forum | Thu Oct 14 14:11:33 EDT 2021 | SMTA-64387257
Hi All, We are currently looking to add an Xray inspection system into our process. We build high density assemblies with ultra fine pitch BGAs, 0201's, QFN's and every package type one can think of. We would like to use the inspection system to v
Electronics Forum | Tue Oct 19 13:20:40 EDT 2021 | davef
Info@Xpresscreen.com O: 336-722-2500 800-597-9530 F: 336-722-2575 xpresscreen.com/ Saati S.p.A., Via Milano, 14 22070 Appiano Gentile (CO) - Italy; O: +39 031.97.11 F: +39 031.933.392 info.it@saati.com">info.it@saati.com https://www.saati.com/
Electronics Forum | Wed Oct 27 07:34:14 EDT 2021 | reinhardk
Hi, we have a DAGE Assure machine, and we are happy with the results it gives us. Even without proper teaching the results were good (for common part sizes). *With* proper teaching results are even better. Only in certain cases results are unusabl