Electronics Forum | Mon Apr 17 15:39:35 EDT 2023 | tey422
That's depend on how many wash cycles you would need to completely cleans the board within 1 batch. Most of times you would need more than 2 wash cycles (that's already about 30 mins just 2 wash cycles), it can be up to 5 wash cycles alone. Also kee
Electronics Forum | Tue Apr 18 12:03:30 EDT 2023 | dskling
No. they struggle to move a little but not a full cycle. We have replaced the 3 control boards on the back door, both EMI filters, check and replaced all fuses, pulled the clinch head and swapped it with another working clinch head and that blew a c
Electronics Forum | Thu Apr 20 22:08:07 EDT 2023 | saucyshawn
Mycronic is very expensive. But it does have a lot of good options and feeder count. JUKI I have always found to be limited to number of feeders and flexibility of individual machines. If you are upgrading from MannCorp there may be better options
Electronics Forum | Fri Apr 21 07:18:40 EDT 2023 | spoiltforchoice
I had quotes for a MY100 -14 a Juki KE-1080 and an iPulse M6ez back in 2011 and at that point all those machines were about the same price with a light feeder package. The MyData however was the only one configured with smart feeders, a tray feeder a
Electronics Forum | Fri Apr 21 15:38:25 EDT 2023 | jamesatqkits
Hi Rob, Yes I agree with everything stated. Lots of things can cause this. I have gone over everything mentioned in your response. The thing is, I could do a simple drag and had no issues, then a few bridges then more. So I have checked everything, m
Electronics Forum | Tue Apr 25 20:22:32 EDT 2023 | ttheis
We have a line running GSM1 machines and we are considering upgrading to GX-11S machines with FJ3 heads. Does anyone know if the GX-11S machines can take pneumatic feeders from the GSM machines? We have a very large inventory of the pneumatic and ele
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
Electronics Forum | Wed May 03 13:35:00 EDT 2023 | ttheis
Thanks, Deni! We're replacing two 4-spindle GSM's with two GX-11S with Flex3 front and IL4 in the rear. These we plan to use a mix of our pneumatic & 24V feeders as well as high speed feeders as we acquire them. The sellers advised that the 24V kits
Electronics Forum | Thu May 04 11:37:25 EDT 2023 | proceng1
Thank you. I do feel that the document is very lacking in detail. It mostly says "yes, it needs cleaned. Make sure the cleaning process doesn't screw it up". The majority of boards that get wiped are already populated on the other side. So that lim
Electronics Forum | Thu May 04 13:16:07 EDT 2023 | tommy_magyar
If I would need to investigate this claim, I would ask the following questions: - was traceability used when this product was manufactured? - was testing mandatory when this specific product was built? - is the test covering the QFP we are talking ab