Electronics Forum | Tue Sep 28 16:45:04 EDT 1999 | Doug Philbrick
| | | Hiya, | | | | | | Could anyone please suggest recommended manufacturers of | | | IR rework stations for the removal of various SMT comps. | | | | | | Cheers | | | | | I have 2 customers who went from hot air system to a PDR and they love it
Electronics Forum | Thu Sep 23 10:38:50 EDT 1999 | Dan Lambert
| Is any one else out there running a Contact3AV machine in a small batch size (4 offs to 20 offs)environment ? | | Obviously you cannot expect a high utilisation figure running small batches, setup etc; but has anyone achieved an optimum ? | | I h
Electronics Forum | Wed Sep 22 16:48:40 EDT 1999 | C.K.
Question for you SMT guru's out there. What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: 1.) Custom b
Electronics Forum | Wed Sep 22 16:51:05 EDT 1999 | C.K.
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
Electronics Forum | Thu Sep 23 10:20:58 EDT 1999 | Earl Moon
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
Electronics Forum | Fri Sep 24 20:33:44 EDT 1999 | Ron Gillam
| | | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y tabl
Electronics Forum | Tue Sep 28 14:00:24 EDT 1999 | Eric Lee Williams
| | | What is the command string used to download updated software | | | from floppy discs to the mcs16b controller? | | | | | Well Eric it depends on what your doing. If your just updating | | the MCS software, start out at the first screen ( UCI s
Electronics Forum | Thu Sep 23 22:31:25 EDT 1999 | Dave F
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Wed Sep 22 06:28:35 EDT 1999 | Bach Huss
Hi All, We have 19 Siemens machine running here and lately I was assigned to come out with a proposal on the wrong part issue on Siemens Machines. All of our machines are equip with siemens part verification in which there the part barcode is scanne
Electronics Forum | Wed Sep 22 03:23:40 EDT 1999 | Jeanjean
Dear all, First, I'd like to thank every one of you who have been a great help for my last questions. Then, I have heard that in multilayer ceramic capacitors, each layer of ceramic was about 3 micrometers at least. When adding the layer (which I d