Electronics Forum | Sun Nov 17 10:50:11 EST 2013 | sara_npi
Hi, I have difficulty on solving unknown nozzle st 17.situation goes like this,almost I run bout 6 models each day,but 1 to 2 models only have this problem.I almost done a few basic troubshoot such as clean censor st 17,clean cluch using prope
Electronics Forum | Thu Nov 21 20:23:26 EST 2013 | dandin87
We have a Speedline MPM UltraPrint 500. The Hard drive currently in it has bad sectors, and so I had tried to install a new hard drive and used the installation folder from the old one to re-install SigmaPro 32. When I start it fails to find the Mete
Electronics Forum | Thu Jan 30 06:36:37 EST 2014 | sigmaprint
We still have two of these machines as well. Let > me know if you still need the software, I think > we have a copy around here I can copy. > > If you > have an FTP site I could probably upload a CD > image for you. > We still have two of the
Electronics Forum | Fri Nov 22 16:55:30 EST 2013 | hegemon
Head and Pillow defects beneath a BGA are difficult to find, no matter what the equipment is on hand. Since you do not appear to have access to tools that would help you, or $$ to purchase said tools, I might recommend that you use an outside source
Electronics Forum | Mon Nov 25 18:43:29 EST 2013 | hegemon
Without the proper tools in house you will not be able to determine anything but the most obvious problems. At minimum, some side looking microscope that would allow visual inspection of a row or two, and to be able to rule out bridging. Using that
Electronics Forum | Sat Nov 23 12:39:18 EST 2013 | joeherz
We installed a Soltec Delta 3 a few months ago and have been trying to run with a VOC free no clean. We're using SN100C in the pot. We are spraying the material and have top/bottom preheat. Evaporation of the water in the flux is a bit of a stru
Electronics Forum | Mon Nov 25 03:14:57 EST 2013 | mg2013
Hello @ the specialists, we have a Nordson Asymtek SL940 to coat our pcb's. We can use the valves SC100 and SC400 for conformal coating applications. We use the Humiseal 1A33 as the conformal coating. Now we would like to use the standard 1A33 in th
Electronics Forum | Wed Nov 27 09:43:17 EST 2013 | mchawg
We recently rebuilt the generator and power supply on our '97 vintage Optiflux Ultrasonic fluxer. That cleared up all its issues except. Ultrasonics are reported by all indicators to be running in both Setup and Run mode, however, the nice rooster-t
Electronics Forum | Fri Dec 06 14:39:52 EST 2013 | davef
Depending on how much you require, there may run into some minimum material thresholds. * Research on 3M website: http://solutions.3m.com/wps/portal/3M/en_US/Electronics_NA/Electronics/Products/Product_Catalog/~/All-3M-Products/Industry-and-Professi
Electronics Forum | Sat Dec 14 02:29:52 EST 2013 | padawanlinuxero
Hello I hope this helps For a component with axial leaded - vertical The clearance of the component body or weld bead above the land is 1.00mm (0.039in) Component body must be perpendicular to the board The overall height does not exceed maxim