Electronics Forum | Sun Mar 07 09:24:55 EST 1999 | Scott Cook
| Hi Ya'll... | it's a Soltec Prisma and the conveyer keeps jamming. What it's doing is up at the exit end where the drive motor is, the chain keeps wrapping itself around the drive sprocket and jamming...this is on the backside rail, the frontside
Electronics Forum | Mon Oct 14 03:03:34 EDT 2002 | msimkin
Mike, I have been using a fully synthetic motor oil on the links of my chains of my Hella for 7 years now, and have had no problems. As long as you do not place the oil on the fingers, where it makes contact with the PCB, then you will have no probl
Electronics Forum | Wed Dec 11 12:43:03 EST 2002 | kerryn
We use our ultrasonic stencil cleaner. Before we change the wash solution, we clean pallets, chains, fingers, etc. It does a good job and takes only a few minutes.
Electronics Forum | Mon May 24 10:17:37 EDT 2004 | Sue PH
Our old Trieber Wave Solder machine is needing it's conveyor chains to be cleaned. Does anyone out there have knowledge to share about dealing with this problem?
Electronics Forum | Mon May 24 11:31:49 EDT 2004 | russ
Search the archives, We had a lengthy thread on this a little while ago. use "chain cleaning"
Electronics Forum | Thu Jul 06 09:51:25 EDT 2006 | slthomas
lol! chain-to-chain xfer on a seq./inserter? Sounds vaguely like something I've seen before.
Electronics Forum | Wed Aug 09 12:18:06 EDT 2006 | PR
We had to replace the chains on our Omni as well. We used a non-approved oil which build up so much carbon the links would not move. Since using the high temp oil they recommend, no problems.
Electronics Forum | Wed Aug 09 14:17:49 EDT 2006 | chrisgriffin
I had a similar problem once. It turned out to be sprocket bearings. The sprocket was so hard to turn, the chain would stop a couple times per shift.
Electronics Forum | Wed Aug 09 16:46:49 EDT 2006 | nitro
We use the Tribol 930/100 Synthetic oil. Also, check the drive motor chain on the output end of the oven. I have seen the set screws back out of the drive gears, and it will kind of pop at times while running.
Electronics Forum | Mon Aug 14 02:24:20 EDT 2006 | AR
When we had problems on our Omni 5 with fluctuating chain speed, the problem turned out to be the Dart speed control board. After replacing the board the problem went away.