Electronics Forum | Fri Sep 05 11:32:31 EDT 2008 | realchunks
I just bought some of XPM3 series. according to Vitronics, you shouldn't go through more than two quarts a year per each oven. Have you experienced this? If not then I too would be interested in a 2nd source.
Electronics Forum | Thu May 28 12:05:11 EDT 2009 | wrongway
We have A heller 1809 2005 model have replaced the chain drive motor twice have replaced 2 top blowers and one bottom blower as far as reflowing the solder performance has been great. the tech support has been great as well. we run 3 shifts 5 days
Electronics Forum | Wed Oct 07 10:04:07 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more
Electronics Forum | swag |
Mon Jun 27 18:56:18 EDT 2011
Electronics Forum | Mon Oct 24 18:05:24 EDT 2011 | paola
One of our customer had request for us to comply with the law and to retrieve information from our supply chain for the compliance . We are just electronic distributors, as the QM I need to request the resources necessaries to flow down the requireme
Electronics Forum | Fri May 04 11:47:56 EDT 2012 | pctech
Hi, It's not advised to hard-down the re-flow oven.There are two reasons for that ; extreme thermall difference in temp. will cause chain and drive shafts to warp and T/C's to crack.Let your "cooldown" profile do this safely within 45 mins. to an hou
Electronics Forum | Wed Sep 19 10:23:38 EDT 2012 | cbeneat
We Have 3 Vitronics XPM2's. I know nothing about any other manufacturer, but Vitronics has been extremely reliable. 2 Shifts 5 days a week for 6 years, and have never replaced a blower. Have had to change a few overtemp switches, and have had a fe
Electronics Forum | Wed Dec 12 02:26:35 EST 2012 | ryanmatthew
Hello Friends, Well Come to you. Simply, admirable what you have done here. It is pleasing to look you express from the heart and your clarity on this significant content can be easily looked. Remarkable post and will look forward to your future upd
Electronics Forum | Thu Feb 07 16:37:02 EST 2013 | jasowiii
This is good information but I had hoped to get specific manufacture and/or model infomation on equipment that someone has experience with. For instance I bought a Husqvarna model 455 (rancher) chain saw last year. I cut through 3 cords of fire wood
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some