Electronics Forum | Fri May 13 10:13:24 EDT 2016 | esoderberg
Have used a Pressure Products N29 stencil cleaner for many years with outstanding results. The fluid is Zestron Vigon SC200. Tank holds 14 gallons that lasts for 1 year providing that you change the filters every month and makeup the fluid evaporatio
Electronics Forum | Fri May 13 02:43:21 EDT 2016 | karts22
Hi, We have several fixtures for GenRad 228x tester and would like to change sensor plates as they are quite worn. The problem is that 3 fixtures have different plate sizes for the same IC, side length is 10-12mm. What would be the best size for sens
Electronics Forum | Tue May 17 14:10:42 EDT 2016 | bobpan
You should get hold of Automation Technical Services and see if they can tell you how to change to indexing. If you find out....post it on here to help others. I myself have never used ATS feeders (just never ran into them anywhere). Bob
Electronics Forum | Tue Jul 19 13:25:08 EDT 2016 | emeto
thanks for the great reply. Now you make me think that we should change both the motors and the platens. That looks like a lot of money for a 10year old machine. It looks like it has some issues with the wiper as well. do you think 20K for parts and
Electronics Forum | Wed Jun 22 01:57:28 EDT 2016 | sachinverma
we face the problem to last month dry solder issue.when we found PCB is dry. (PTH not fill not properly)then we change the parameter like flux Tank pressure increase 130 to 250. after these activity PCB is ok no dry solder found......but problem is o
Electronics Forum | Mon Jul 11 13:21:40 EDT 2016 | bradholland
well there you go. I found that trying different values in the "Placing Stroke" had a big effect. I changed it to 2mm and it placed them well, but I could see the board also flexing a little, went to 1mm and the problem came back, so have sat in th
Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Wed Aug 24 11:32:08 EDT 2016 | mnorthey
Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0
Electronics Forum | Mon Aug 08 08:32:42 EDT 2016 | emeto
Just get a regular scale(small thin one - like a scale for kitchen). Mount it over a PCB and simulate placement with certain force. Hold the nozzle down for long time in order to register accurate reading from the scale. Then, just change parameters
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
.gif)
