Electronics Forum | Mon Feb 10 17:04:35 EST 2014 | globalpowerproducts
I am having a problem producing clean boards when i run them through my new machine. Currently i use an Electrovert system that uses trays and we are trying to upgrade our equipment so I bought a SHEO 8250 and it is making the boards dirty and lots o
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Wed Feb 26 04:28:39 EST 2014 | chongns
Hi All member I have a problem on the stable down the color of the white solder mask PCB. first, i tough the color differences was cause by the solder mask ink, but after a close look, the color change are cause by the copper under the solder mask
Electronics Forum | Thu Mar 06 17:27:17 EST 2014 | bobpan
Does this happen with just 1 gantry? If so...I would think your encoder in that gantry/axis needs cleaned. I have seen digital i/o cards cause this issue. But usually you will notice this when opening and closing the doors. The head would sometimes
Electronics Forum | Tue Mar 25 14:19:02 EDT 2014 | barryg
Hello everyone. I have a question pertaining to solder irons, tips and solder stations. We recently have set up our lead free wave and reflow oven. We still have quite a few projects that require leaded solder. I was curious how others handle rework
Electronics Forum | Sun May 11 17:29:17 EDT 2014 | bobpan
Most times when the machine oscillates when closing the doors it will be a problem with the digital i/o cards. I would check that the dip switch settings are correct. If they are correct i would look at replacing both of the cards. The boards are sub
Electronics Forum | Mon May 26 04:39:49 EDT 2014 | sarason
Damn near impossible. You need to see a real change in the difference between the 2 elements you are reading. So to give yourself any hope run 2 long traces one top one bottom up the length of the board. Then compare to 2 wriggly traces at one end (o
Electronics Forum | Thu Jul 10 13:24:59 EDT 2014 | sargeredarmy01
Ok so here is where I am with everything. I pulled the cylinder and cleaned it out. Didn't find anything out of the ordinary inside. I set everything back up and tested it. Still nothing. I went into the I/O map and tracked down that input, I then
Electronics Forum | Sun Jun 22 13:24:49 EDT 2014 | davef
I don't know. We never had craziness like this before lead-free. You should have the yellowish-metal analyzed to be sure. Guessing: You're seeing this color on the terminations of components, not on the bulk of the SnX solder connection. If that's
Electronics Forum | Wed Jul 16 14:21:15 EDT 2014 | toddp2012
Hi all, we have a Speedline Technologies ELEOCTROVERT/Aquastorm 200. In January we stared supplying it with pre-filterd to the DI cabinet next to machine so our large media would last longer. All was fine for about 4 months and then we started gett