Electronics Forum | Fri Dec 10 02:26:16 EST 1999 | Tracy Guo
Hi, I'm facing smear after printing on DEK288 using reverse squeegee at the edge of panels. I've checked the fixture, printing parameter, stencil, solder paste. What else can I do?
Electronics Forum | Mon Dec 06 12:33:49 EST 1999 | Wolfgang Busko
Hi Glen, is it a wavesoldering or reflow problem ? Check the difference between the boards that show this symptom and those that doesn�t. Are there differences in the material, the handling, the processes, pitches etc. Looking at that should help you
Electronics Forum | Sat Dec 04 12:47:36 EST 1999 | Robert Halliday
Run a DTI over the X and Y edges of the table to ensure that your XY table is flat, adjust the four small screws to suit. Also check that the Z cams are not worn and that the Z cam followers are not siezed or worn(they are prone to flat spots when wo
Electronics Forum | Wed Nov 24 15:50:49 EST 1999 | JAX
Larry, Check the archives. You can even look under your own name. You have anwsered this question in the passed(**)
Electronics Forum | Tue Nov 30 16:44:01 EST 1999 | Dave F
I think Multitronics is(was) Dynapert. Check the archives. That may give you a wider audience for your question. Consider requesting a customer list from Multitronics. Ta Dave F
Electronics Forum | Mon Nov 22 18:32:31 EST 1999 | Jason Nipper
Thanks Rob, I figured a PM schedule would be a must. I will be checking out Durapol in my next pallet.
Electronics Forum | Fri Nov 12 15:20:13 EST 1999 | Doug Callaghan
A Tips window appears everytime I visit the Forum, even though I have checked the box to insure that it doesn't reappear on the next visit! Why? Doug
Electronics Forum | Wed Nov 17 07:20:10 EST 1999 | robert oertner
Sounds like you are running your conveyor too fast. Check your profile and see if your board is getting hot enough "max 125c on topside prior to hitting the wave. If so then slow it down, if not then increase your preheats and slow it down.
Electronics Forum | Wed Nov 03 18:21:12 EST 1999 | JAX
Can somebody help me find some information about Components? ( i.e. terms and definitions ) I have checked the library and it only seems to have info on SMD components. Any info would be appreciated. Thanks in advance,
Electronics Forum | Thu Nov 11 15:12:29 EST 1999 | Jamie Marsh
I found a lot of information about UniCam at their web site. Check it out. http://www.unicam.com