Electronics Forum | Thu May 07 08:12:06 EDT 2009 | milroy
Hi I recommend you to check the exhaust sensor, the ERSA EWS500F is sensing the exhaust before it activates the fluxer. If the exhaust is not working then machine does not start to avoid the sprayed flux emit to the work environment. There is a sens
Electronics Forum | Thu Sep 23 18:56:42 EDT 2010 | slwolbert
Greetings all: I may have a simpler issue going on with this Fuji IP2 machine I'm struggling with. IP2 will boot and zero set, but if production is to be done, during the nozzle check sequence it gives a check nozzle message. This is due to the no
Electronics Forum | Fri Sep 02 11:26:50 EDT 2011 | steffenr
Overkill for sure! Program to BOM: Shouldn't have to verify the program to the BOM once it's been verified unless there is a change. Feeder to BOM" There should be some type of instruction that specifies that part goes on what feeder and where the
Electronics Forum | Tue Aug 20 13:01:48 EDT 2013 | sevenzero
I read through this thread somewhat and checked out the pictures. I've programmed TH lead checks on a newer Yestech and an older Mirtec. I personally use the Yestech white-top/histogram check and the only solder inspection Mirtec has. In my experienc
Electronics Forum | Wed Aug 01 08:58:02 EDT 2018 | 2219576
Please check the solder paste height near PCB edges, Please check board clamping during solder paste printing. Please check tooling support boards must be fixed during the printing process. try to set wiper cleaning frequency and fine tune for best
Electronics Forum | Tue May 07 13:49:05 EDT 2019 | tey422
Like I stated before, I am not familiar with the machine. I can only make suggestions. If you found solder paste on the nozzle, clean it off to prevent part stuck to the nozzle tip. I would also check if the nozzle tips are being worn off; uneven we
Electronics Forum | Fri Feb 09 11:48:09 EST 2007 | realchunks
0.25mm tilt? That's pretty small depending on you BGA size. Is it failing? Or just your Q.E. being anal? What size BGA we talking about? What ball count? Just one board? Maybe cheaper to just repair. Now assuming there is NO part under the BGA