Electronics Forum | Mon Oct 21 11:05:57 EDT 2019 | tey422
With the given update you provided, that would rule out the nozzle tool issue. If the parameter looks fine, then the issue would be somewhere around the nozzle tool bank. Need to check open and close release. If the nozzle seats flush "not tilted" w
Electronics Forum | Mon Oct 28 21:17:40 EDT 2019 | sarason
The OCD in me suggests you chase down Windows Time/Date configuration ,also when you power up the machine check the time/date in the BIOS I presume these machines are windows based just looking in the Assembleon website. sarason
Electronics Forum | Wed Oct 23 02:08:21 EDT 2019 | bukas
sounds like bad electrolytic capacitor, check if your drivers have any swollen capacitors or otherwise damaged caps
Electronics Forum | Thu Aug 27 09:29:04 EDT 2020 | serge_pirog
Yes, I calibrated the height, no error. How can I check that pressure was compensated? If we press button "continue" after some cycles of printing system will show "error".
Electronics Forum | Wed Nov 20 21:30:36 EST 2019 | sssamw
first of all, you need check the strain caused by interference during connector insertion. If must done by SMT, then a claw would be better than nozzle.
Electronics Forum | Sun Nov 24 20:43:15 EST 2019 | sssamw
If you want to check if solder mask on tented via, better to do cross section to have a clear view. Sometime supplier will not tell you the truth once you ask question for potential quality issue.
Electronics Forum | Fri Dec 20 05:44:43 EST 2019 | hemantpang23
Thanks for your reply We checked all the hardware found ok voltages are as per specifications Suspecting software issue but don't have software for installation Please confirm if you have this software version 04.03 so that we can have last try
Electronics Forum | Mon Dec 02 20:05:25 EST 2019 | crystal12
personally, I do allow. usually, they will do some design for manufacturability change. this cannot be avoided. I have read an interesting article talking about this question, maybe you can check: http://www.starivergroup.com/News/info.aspx?itemid=10
Electronics Forum | Fri Dec 13 04:29:17 EST 2019 | pavel_murtishev
Davef, Exactly. I do really appreciate your input. I have sent you my e-mail. Will check the standards. Regards, Pavel
Electronics Forum | Fri Jan 31 15:02:50 EST 2020 | travishemen
Check out Cogiscan or Bartector. Im sure there are others but these are the two I've heard of. They make solutions for what you are trying to do.
