Electronics Forum | Wed Mar 03 14:25:02 EST 2021 | astarotf
Hi Spoiltforchoice Thanks for the comment. With the line encoder readers that the machine brings, we performed a positioning reading check, which showed us the increase or decrease in the path that the heads make, with which we conclude that it is re
Electronics Forum | Thu Mar 25 13:52:36 EDT 2021 | ephan
I bought this printer from a third-party source. The machine was running well until one day when we tried to turn it on and the screen just came up blank (I already checked if it was a monitor problem). Does anyone know why this happened and how to f
Electronics Forum | Fri Apr 16 17:20:34 EDT 2021 | astarotf
We are currently producing a project that brings a TQFP64. But some boards do not solder the component well with its ideal fillet, some are well soldered when they come out of the reflow oven, but some are not. Can the pins be sulphated? How can we c
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Mon May 10 12:04:50 EDT 2021 | rsikora
Thanks for your reply. I haven't checked or used WinMCS for troubleshooting. Based on your reply, I looked or WinMCS within Explorer and could not find it. Used the autosearch function for "MCS" and "WinMCS" and the autosearch did not find it eith
Electronics Forum | Fri May 14 16:49:17 EDT 2021 | winston_one
Agree with WiIIR and also can recommend to play with vaccum pump RPM . Slower vacuum increasing have help me to resolve one problem caused by the vacuum (it was solder splash from BGA balls, but the reason can be similar to your case). Also check i
Electronics Forum | Tue May 25 15:39:56 EDT 2021 | jamesatqkits
Hi Bukas, thanks for taking the time to respond. Drive is in good shape, everything seems OK. The first thing I did was make a copy of the drive. I should check all of the PCB's and make sure they are seated properly. The Samsung part of the assembl
Electronics Forum | Wed Jun 16 14:07:15 EDT 2021 | oxygensmd
For example, I had the same problem on my Rehm oven. It was in calibration mode. The machine is going to maximum transport width but sensor wasn't reached and the machine stucked in calibration mode. Maybe there are manual mode for transport width a
Electronics Forum | Fri Jun 18 09:53:51 EDT 2021 | shmevan91
Hi, we have checked all of those and beenm in contact with heller but they said they will need to send an engineer out as they are also out of ideas, was hoping someone might've had the same issues as we have two ovens doing the same thing, wont move
Electronics Forum | Fri Jun 25 17:33:23 EDT 2021 | SMTA-64387687
Since you changed the motor and the encoder, we can rule them out. Did you check the ribbon cables for wear? Is it failing on the same 3 components? Is it failing around the same area on the board? Does it fail when you cycle a tool, multiple times?
