Electronics Forum | Fri Aug 14 10:02:23 EDT 2015 | swiese242
Yes your CP8 should place these flawlessly. I would calibrate the machine and check your nozzles. We have some CP7's and they rock. We use a .4 nozzle for the 0201's with no problem. Always check your program, feeder, nozzles, and nozzle check before
Electronics Forum | Thu Jan 21 15:36:37 EST 2016 | brantco
I have the Error message E00900 i have checked the troubleshoot and it says to check SP1 XP6 and Y1 i have checked SP1 its ok, Relay XP6 seems ok Y1 i dont know where it is located here is the error "Air Pressure Fault" any help would be greatly
Electronics Forum | Thu Aug 17 06:02:37 EDT 2017 | smeissner
Is anyone using an AOI machine for through-hole > checking? We have a need to check post-build on > some PCBs', but there doesn't seem to be any > obvious AOI solution. > > Is there such a beast > available? Check Goepel. They developed a Spec
Electronics Forum | Wed Jan 29 07:10:19 EST 2020 | dontfeedphils
I'd recommend checking with the manufacturer of your SMT equipment and checking into the feeder verification solutions they have. Combine that with a buddy check and true first articles before the line can continue to run the balance of the job an
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo
Electronics Forum | Fri Aug 28 19:54:05 EDT 2020 | emeto
From what you explain: 1. check all movements X,Y and Z are moving free while machine is off. 2. Resit all driver cards. 3. Check interface cables or boards. Not sure if Juki is using CAN or other interface standard, but random motor errors might be
Electronics Forum | Sat Mar 25 12:51:14 EDT 2023 | rgduval
Swap mot cards and see if the error moves. Of it does, your issue is the mot card, if it doesn't, your issue is one of the above. Try calibrating in the service menu. Check your friction readings. Check the x-encoder (attached to the motor).
Electronics Forum | Fri Mar 17 21:44:14 EST 2000 | sosina_outry
Daren: suggestion from a friend of mine 1. Is residue on the top or bottom of the board? If on the bottom, then you might need to do solder dedross. if on the top, you might need to check 1. after spray flux, check for any excess flux on the top of
Electronics Forum | Fri Jun 15 13:06:15 EDT 2001 | CPI
I Agree with Dave, Check spec on cap some devices have temp constraints (can exceed x degrees for more than x time or can not exceed a certain ramp rate). Check that then go through the rest of the process chances are its not your machine if no other
Electronics Forum | Sun Sep 09 14:34:50 EDT 2001 | darburch
Eric Whenever I see a board come out of the chipshooter missing parts the first thing to check is the support pins. However if you have checked table and part height I assume that you have also checked the pins. So the next thing to check is the vac
.gif)
