Electronics Forum | Wed May 18 19:12:26 EDT 2005 | HOSS
Hello, Assuming that your dwell and coverage at the wave are in order..... Have you checked the angle and pressure of your fluxer air knife? You can only count on capilary action to a point. The air knife, set correctly, will help get your flux t
Electronics Forum | Thu May 19 09:16:52 EDT 2005 | nelly
Check when you set up the board that it is positioned in the centre of the table. When the calibration is carried out the table drives away and then returns to capture the fiducial, if there is not enough travel left in the actuators then this is th
Electronics Forum | Mon May 23 16:38:48 EDT 2005 | thaqalain
0 0 0 0 1 0 1 0 0 1 1 1 Please u check sequence of rows,I think above is correct sequence.
Electronics Forum | Tue May 24 11:07:07 EDT 2005 | pr
Check "WP Sales" or "SMT Research", I know they have Fuji replacement parts like nozzles etc. I suspect they have feeder parts as well. good luck, pr
Electronics Forum | Tue May 24 10:37:53 EDT 2005 | pr
Topline sells kits with the dummy components and the boards. They will also give you the CAD DATA for the placements on the board. You can also use these as "gold boards" to check placement accuracy and machine repeatability. http://www.topline.tv
Electronics Forum | Wed May 25 19:11:49 EDT 2005 | jsloot
That I can do, checking the placement height that is and the clamps. I believe my clamps are 4mm. If your nozzles have survived 5 years how many placements is that...roughly? In the billions?
Electronics Forum | Thu May 26 06:48:34 EDT 2005 | Base
Even worse, you might be running into patents that prohibit you from building the same stuff they are. Might wanna check that first, because I doubt that Fuji or whoever will grant you a license.
Electronics Forum | Thu May 26 14:33:45 EDT 2005 | PeteP
CircuitCam offers great support, a superb product and CheckPoint can handle the Bill of Material comparison tasking you asked about. Friendly staff, good training and I do not receive endorsements $$$$. Just a good product.
Electronics Forum | Thu May 26 17:43:46 EDT 2005 | OverTheHill
Aegis, yup, very pricy. We just signed a PO for CircuitCam, CheckPoint and Fusion. Expect to have it up and running within a month. Sorry, no use info, but will keep you informed.
Electronics Forum | Thu May 26 14:29:16 EDT 2005 | PeteP
An elusive cause can be Bill of Material Quantity errors vs. actual placements. Check the programs to the Bills and designators on the BOM to Qty. if the postings above do not net results.