Electronics Forum | Wed Oct 03 09:48:55 EDT 2012 | jimmyboz
I think 29. There is a help key on the televideo kbd, the sticker that says "help" may have fallen off or is now illlegible, its in the upper right of the kbd. I can check for the number if you still have problems
Electronics Forum | Fri Oct 26 13:43:54 EDT 2012 | whispell
Make sure your machine configuration is correct. You may have something assigned to the machine that is no longer there. For 24V check to make sure all of the E-stop jumpers are plugged in.
Electronics Forum | Wed Oct 17 08:09:09 EDT 2012 | fujiphil
This problem is caused by poor pick-up. Check the pick-up from MTU to shuttle, then shuttle to placing head 1. If the pick-up is not centered, adjust proper data.
Electronics Forum | Tue Oct 16 10:39:35 EDT 2012 | trottmann
Hello, are you useing any Through hole AOI in your conventional Hand Assembly and what Typ is it pre- oder post-solder? And what errors are you ecpecting to detect? -missing component -component Offset -polarity Check -or??? Is there Any Manufactu
Electronics Forum | Thu Oct 25 11:15:55 EDT 2012 | aj
are you sure the zone 5 blower is running? sounds like it isnt.... no harm to check all blowers while you are at it.
Electronics Forum | Fri Jan 04 07:28:46 EST 2013 | beej
Thank you guys. I will check this stuff out. It quite possibly could be something we have done wrong. Thanks again for the feedback
Electronics Forum | Fri Jan 18 09:35:49 EST 2013 | dyoungquist
Just because a certain profile works good for a board with a BGA does not mean it is automatically the correct profile to use for a different board that contains an LGA. Have you run a separate profile check with the board containing the LGA?
Electronics Forum | Tue Jan 22 13:26:04 EST 2013 | smtequip
Hello Felipe - I think I have one, but I am on the road today. I will check for you tomorrow. Best regards, Scott
Electronics Forum | Thu Feb 07 01:21:44 EST 2013 | alamgir
Thanks a lot for detailed information. I will check whether I could get required boards and gerber files from them. I have the BenchMarker II board, I only need top layer (stencil) gerber file for the purpose of verifying repeatability of SPI machin
Electronics Forum | Fri Feb 15 12:29:35 EST 2013 | mikesewell
What foil thickness? Type 3 or 4 paste? Have you checked your area ratio(s)? You could overprint or drop your foil thickness by one mil to improve the ratio and paste transfer. As always you can search the fine SMTnet archives for more info.