Electronics Forum | Wed Mar 13 17:17:42 EDT 2013 | isd_jwendell
I don't know your machine, but on mine the interlock is the large access door. It's done so that you cannot open the cover while running, but it also checks for a closed door at startup due to head homing sequence. Yours may be similar in that it won
Electronics Forum | Mon Mar 18 09:19:48 EDT 2013 | marcelorotofrance
I can move the axes XYUV just in short steps through the "MANUAL NC" function. The axis encoders seem to work; the readings of position follow the axis movements. However the actual position of the head has nothing to do with the readings at the disp
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
Electronics Forum | Mon Mar 25 13:18:05 EDT 2013 | emeto
Hello, I have an issue with SOD 923 out of the oven. The part looks grainy, doesn't show a good wetting and looks like it has to be touched up. Everything on the board looks beautiful except this part. I tried with the profile, I checked the pad des
Electronics Forum | Tue Apr 23 15:35:45 EDT 2013 | dyoungquist
Check out IPC-A-600. Revision G (July 2004) section 3.2.3 (surface) and section 3.2.4 (internal) give min/max thicknesses for various weight copper. The min also changes depending on what class (1-3) standard you are working to.
Electronics Forum | Tue May 07 13:32:15 EDT 2013 | bobpan
Sounds like you may have a z-axis problem. I would check the axis out and run the z rod up and down by hand to see if there is a problem....sticking,sensor/flag broken....etc. Maybe you can unplug the z-axis card and then turn the machine on to see i
Electronics Forum | Tue May 14 08:08:04 EDT 2013 | emeto
Hi, BGAs should be placed by camera recognition if you have one(that helps to eliminate defects as missing balls...). If you don't, check the parameter for the laser level(height). In your case I think you should use the body as a measure level. If
Electronics Forum | Wed Jun 12 14:36:15 EDT 2013 | rollon65
Hi Bert I had belts made for my conveyors using Habasit material made by Benson's belting here in U.K. They have been running now for 6 years or so and I am very satisfied with them. We are 12K miles away but check out their website at http://www.
Electronics Forum | Tue May 28 08:32:41 EDT 2013 | emeto
Hi Eric, your problem looks like a printing issue - if the part(or group of leads) missing solder is always the same. I would say you should check: 1. Stencil for any damage at this area 2. Squegee for damages 3. Adequate pin support un der the boa
Electronics Forum | Thu Jun 27 23:49:40 EDT 2013 | cedric77
I had a solder paste SAC305 T4, with flux loading of 11.5%. After retrieivng out from fridge(5deg) after 48hrs, the paste turn dry (like dry mud? and after double checking the flux loading it becomes 12.5%. Has anyone ever experience this or any opi