Electronics Forum | Fri Jan 24 06:45:19 EST 2020 | alpha1
Depending on your equipment. If you are running stand alone equipment. Separate Sequencer and Axial Inserter there's not much you can due expect check the process. The axial should still catch at least most of the defects. If you have a combination u
Electronics Forum | Tue Jan 28 16:47:31 EST 2020 | jede
We are running a Juki SMT line (3RAL and 2080E). I am not sure there is an option for a component verifier. My thought is a barcode/scanner set up and I am in the process of working on this but waiting on Juki response on a file question. We do use
Electronics Forum | Mon Feb 03 13:30:16 EST 2020 | scotceltic
Check into Bartector. Used this solution for 15 years at a previous employer. As long as your parts are labeled correctly (correct part number matching the mfg part number) then Bartector will have the operator scan the feeder to the part label. I
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Tue Feb 18 14:46:38 EST 2020 | bilalfarooqi
Hi all, We were able to fix the issue. We replaced the MOT cards with the MOT cards in the good machine. That, however, did not resolve the issue. The issue was very basic; one of the fuses (fi fuse) located to the left of the MOT cards became open.
Electronics Forum | Tue Feb 25 03:10:12 EST 2020 | tamasmagyar
Hi Tristan, *Missing .mac files or cli folder* - I suppose you copied the program from one version/index to another. If you to that, you have to rename not only the program folder and the files in it, but also you have to modify the paths in program
Electronics Forum | Tue Feb 25 03:32:58 EST 2020 | bukas
hello guys, I got a problem with MAIN START switch on Samsung CP45FV NEO. The switch itself works, and it activates contactors #1-1 #1-2 and #3 but after pressing READY button there is en error msg reporting that MAIN START has not been pressed. Alre
Electronics Forum | Wed Feb 26 13:26:24 EST 2020 | rgduval
I'd agree with getting a stencil fully cut, and taping the pads you don't want paste on. But, I'd also check with the people that will be doing the hand soldering to see what they prefer. Some people prefer soldering on bare pads, some prefer solde
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Sat Mar 28 06:45:31 EDT 2020 | aswa1111
Hey everyone, I hope all of you doing well this time of the year. We have an old Juki / Zevatech 740 pick and place machine and we got a problem with the vision alignment, every placement is off by 2mils. How can you run an offset calibration on t